Suttle SAM-MS34 Operation & User’s Manual

User Guide 3 x 4 Multi-Switch 40 – 2150 MHz DIRECTV® APPROVED FOR TECHNICAL SUPPORT, PLEASE CALL ZINWELL® CORPORATION (909)444-1518,910-8680 1001 East Hwy 212 Hector, MN 55342 www.suttleonline.com Toll Free: 1-800-852-8662 Local: 1-320-848-6711 Fax: 320-848-2361

With the mounting pin plungers in the “out” position, press the unit into the grid in the desired location, secure by pushing the plungers in. Terminate incoming/outgoing coaxial cable: Install F male connectorized RF coaxial cables from the satellite to the “18V SAT” and “13V SAT” ports. Install F male connectorized RF coaxial cables from the “RX1” through “RX4” ports to the receiver(s). If CATV or antenna signal is used, install an F male connectorized RF coaxial cable to the “ANT IN” port. In this case a diplexer must be used on the output ports to split the satellite signal to the receiver and the antenna signal to the TV. Use the port identification label to record the output locations. p/n 100968-00 Rev. A DIPLEXER TV RECEIVER CATV/Ant. (optional) 75-ohm TERMINATOR To minimize off-air analog signal ghosting or off-air digital signal degradation, the 75-ohm terminators (3 included) should be used on all unused outputs as shown. Any unused cable connected to the output should also be thus terminated at the connector plate. Save unused terminators for future applications. SATELLITE – UHF/VHF/CATV DIPLEXER (optional) Diplexer may be omitted if UHF/VHF/CATV is not needed for the application. In this case connect multi-switch directly into receiver. Satellite