Matador LEGEND 4 Reference Manual

Bunnings Warehouse. For service warranty and Natural Gas Conversion queries call 1800 680 405 or email [email protected] Your purchase receipt is required for all warranty claims. 3-6 7-14 15-16 18-19 20-21 MATADOR INSTRUCTION MANUAL 2 22-23 24 GAS SAFETY / TECHNICAL DATA ASSEMBLY OPERATING PROCEDURE FAULT FINDING CARE & MAINTENANCE PARTS LIST / DIAGRAM WARRANTY CONNECTING NATURAL GAS 17

the installation requirements of your gas supply authority, or the appropriate installation code issued by Standards Australia AS/NZ 5601. Barbecues for use with natural gas are labelled ‘natural gas’ and must be installed by an licensend plumber gas fitter . Check the gas type sticker attached to the barbecue. Minimum Clearances from combustible materials must be: Rear - 450mm Sides - 250mm Top - 1000mm IMPORTANT GAS & SAFETY INSTRUCTIONS Always ensure the barbecue is kept away from flammable materials and the gas cylinder clear of any heat source. When changing over from an empty gas cylinder to a full one make sure this procedure is carried out in a flame free atmosphere. WARNING: Read carefully before assembling and operating your barbecue. And retain the manu l for future reference. Failure to comply with these instructions could result in a fire or explosion which could cause serious bodily injury, death or property damage. Accessible parts may be very hot. Keep young children away. Any modifications of this barbecue may be dangerous. Do not move this barbecue during use. Turn off gas supply at the gas cylinder after use. Parts sealed by the manufacturer or their agent must not be manipulated by the user. This barbecue is only to be used outdoors. Do not store a spare gas cylinder under or near this barbecue. Never operate this barbecue without a regulator. If you smell gas 1. Shut off gas to the barbecue at its source, if possible. 2. Extinguish any open flame. 3. Open hood/oven door. 4. If odour continues immediately call your gas supplier or fire department. Do not connect your barbecue to a gas cylinder exceeding 9Kg capacity. GAS INSTALLATION CODES CLEARANCES HOSE AND REGULATOR SAFETY MATADOR INSTRUCTION MANUAL Barbecues for use with bottled gas are labelled ‘pr ’ ‘ opane gas or Universal LPG.’ Opening at the rear and sides of the appliance provide air for combustion and must not be obstructed. The regulator and hose assembly supplied with the barbecue are suitable for propane and Universal LPG gases. A gas regulator adjusted to have an outlet pressure of 2.75kPA is supplied for connection to the Propane/ULPG gas cylinder. The pressure regulator and hose assembly supplied with the barbecue must be used. Replacement pressure regulators and hose assemblies must be those specified by the barbecue manufacturer. When connecting the hose and regulator assembly to the gas cylinder, take care to avoid unnecessary twisting of the flexible hose. Also, take care to avoid a loose connection with the gas cylinder. Inspect the gas hose assembly when exchanging the gas cylinder, or at least once a year, whichever is more frequent. If the O-Ring or PVC hose is cracked, cut, abraded or damaged in any way, the appliance must not be operated. The complete assembly must be replaced if damaged and when statutory conditions require it. Contact your place of purchase if uncertain. DO NOT use your barbecue in garages, porches, sheds, breezeways, or other enclosed areas. Your barbecue is to be used OUTDOORS. The barbecue is not intended to be installed in or on recreational vehicles and/or boats and should not be placed under any surface that will burn. Do not obstruct the flow of combustion and ventilation air around the barbecue housing. Refer to page 6. LOCATION OF YOUR BARBECUE 3 . Never connect an unregulated gas cylinder to your barbecue. If storing the barbecue indoors. The gas cylinder must be removed. Store gas cylinder outdoors in a well ventilated area. Refer to Page 5 for gas cylinder safety. bubbles will indicate a gas leak. Refer to page 5. If you are unable to correct the leak by tightening the connections, turn off the gas and contact the supplier immediately. After the assembly has been secured, turn on the gas and check for leaks by brushing a soap and water solution over all visible and accessible gas line connections. Include checking those connections which were made by your supplier. The presence of a

Keep children away from barbecue during use and Always ensure that no sporting or physical activities are carried out in close proximity to the barbecue during use and while still hot. IMPORTANT: Do not store or use petrol or other flammable liquids in the vicinity of this or any other appliance. Keep the gas hose away from hot surfaces and protect from dripping grease. Avoid unnecessary twisting of hose. Visually inspect the hose prior to each use for cracks, excessive wear or other damage. Replace the hose if necessary. Never lean over cooking surface when lighting barbecue. Never alter or modify the regulator or gas supply assembly. Ensure the barbecue is set up on a level and stable surface. Do not move the barbecue while in use or when hot. Remove the drip tray before moving. PROTECT CHILDREN TECHNICAL DATA CONNECTIONS INPUTS Inlet thread: 5/8 - 18UNF (3/8 SAE) Gas cylinder: POL Gas type: Natural Gas Gas pressure: 1.0kpa This is a low pressure barbecue and must only be used with the hose and regulator supplied. Your barbecue is designed for use with 4.5Kg or 9Kg propane gas cylinders certified to AS 2469. The gas cylinder should be filled by a reputable gas supplier and visually inspected and re-qualified at each filling. Always keep cylinder in an upright position. Always close the cylinder valve when the barbecue is not in use. Do not subject gas cylinder to excessive heat. GAS CYLINDER USE & SAFETY If you store your barbecue indoors, ALWAYS disconnect the gas cylinder first and store the cylinder safely outside. Cylinders must be stored outdoors in a well area. ventilated area out of reach of children, and must not be stored in a building, garage or enclosed any other until barbecue has cooled after you have finished. Do not allow children to operate barbecue or to swing on handle. DO NOT CONNECT YOUR BARBECUE TO A GAS CYLINDER LESS THEN OR EXCEEDING THIS CAPACITY. NEVER STORE YOUR GAS CYLINDER INDOORS. cylinder only - Do not disconnect hose from the appliance. For storage and cylinder exchange, disconnect hose at the DANGER - IF YOU SMELL OR HEAR THE HISS OF ESCAPING GAS FROM THE GAS CYLINDER: Keep clear of the gas cylinder. Turn all controls on the barbecue to OFF. Extinguish any open flame. If odour continues, immediately call you gas supplier or fire department. label located inside the appliance cabinet door. NOTE: Specifications can be found on the data Main 1.6 11 Side 1.6 10.55 Jet mm(Hi) Input Mj/h Gas type: ULPG Gas pressure: 2.75kpa Main 0.90 11 Side 0.90 10.55 Jet mm(Hi) Input Mj/h SAI-400091 Length Width Height Hood Closed 1522 mm 572 mm 1181 mm 740 mm 1524 mm Hood Open 1522 mm BARBECUE DIMENSIONS

A FLAME. IF YOU HAVE A GAS LEAK YOU CANNOT RECTIFY, TURN OFF THE GAS AT THE SOURCE. CONTACT THE ALWAYS CHECK FOR GAS LEAKS EACH TIME YOU USE YOUR BARBECUE. 1. Make liquid detergent solution by mixing one (1) part liquid detergent and four (4) parts water. 2. Turn burner control knob(s) to ÔOFFÕ, then turn on gas at source. You should follow this procedure after any of the following: ¥ Not having used the barbecue for an extended period of time, ¥ Initial assembly of barbecue, ¥ Any disconnection and reconnection of hose assembly, ¥ Changing gas cylinder, ¥ Upon re-connecting gas cylinder after it has been disconnected for storage. 4 parts water Open 1 part liquid detergent 3. Apply the liquid detergent solution to all visible and accessible gas connections, including the connection to the gas cylinder. Bubbles will appear in the liquid detergent solution if connections are not properly sealed. Tighten or rectify as necessary. CHECKING FOR GAS LEAKS CHECKING FOR GAS LEAKS This babecue is approved for use on Natural gas but must be properly converted from the factory built LP. Contact your service agent for details. Conversion and installation must be by a licensend plumber or gas fitter and comply with local codes MATADOR INSTRUCTION MANUAL 5 OFF SERVICE AGENT