DITEC GOL4-C Programming Manual
Text of the manual
How to Programme your
NEW REMOTE CONTROL
DITEC GOL4-C
How to program your new remote control
There are 2 methods for programming your new remote control.
•
From the receiver:
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board, press the programming button (PRG). The LED
To erase your remote controls:
1. Press the programming button (PRG) on your receiver. Keep it pressed down. The LED light
on the receiver illuminates.
2. To erase all your remote controls, press the button PRG again for 3 seconds.
3. To erase only one remote control, press the buttons you use on your remote control.
4. The LED
