Jensen VM9216BT Installation Manual
Text of the manual
VM9216BT Head Unit
External Microphone
Power / Speaker Harness
NAV104 / Microphone Harness
Hardware Bag
Single DIN Sleeve
Trim Ring
Owner’s Manual
Installation Guide
Tools and Supplies
You will need these tools and supplies to install your VM9216BT:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to re
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation.
NOTE: If the VM9216BT is to be installed in a car equipped with an on-board drive or navigation computer, do not
disconnect the battery cable. If the cable is disconnected, the computer memory may
WARNING! Only connect the unit to a 12-volt power supply with proper grounding.
Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete, reconnect the battery
negative terminal. If there is no ACC available, connect the ACC lead to the power supply with a switch.
NOTE: When replacing a fuse, be sure to us
IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the
installation handled by an experienced technician.
For basic iPod® connectivity, you can use the white 30-pin to USB iPod® cable that came with your Apple device. For
iPod® video or photo playback, you must purchase
