CDA ci522 Manual For Installation, Use And Maintenance

File Specifications

Brand: CDA
Category: Dryer
Model: ci522 (Manual For Installation, Use And Maintenance), prWTgeuIP32fo
File Info: Adobe Acrobat PDF (DjVu)
File Size:
Pages: 20 pages

Download PDF

Download CDA ci522 Manual (20 pages)

Read Online:

Read the CDA ci522 Manual For Installation, Use And Maintenance online using the built-in PDF viewer. This document explains how to operate the device, adjust settings and perform regular maintenance.

Key Pages of Document

Use and Controls

A. The timer - turn the timer knob clockwise until the required programme time around the timer knob is selected. B. Heat setting - select gentle or intensive heat as recommended on the control panel. C. Start - press the start button after selecting the required drying time. • Sort out the clothes into groups of similar fabrics and colours. Check the care label inside the garment. We suggest that fabric conditioner be used to reduce static electricity. Delicate articles e.g. tights should be placed inside a pillowcase. It is better to dry small and large articles ...

Do not block the vent at the front or

base of the dryer as this will impair the functioning of the appliance and could cause it to overheat. This appliance must not be installed behind a lockable door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer. Tumble Dryer Venting Your tumble dryer will release warm, damp air in one of three ways. 1)  Extendable rear venting - a long flexible vent hose is built into the dryer and can be extended from the large opening at the rear of the machine. 2) Fixed rear venting - venting is through the larg ...

an open door or window. The best

solution is to connect the vent hose to a permanent connection through a wall or a single glazed window. This is particularly recommended for small, cool rooms. Front venting machines must be converted to extendible rear venting before a permanent connection can be made to the outside. When using a vent hose, remember the following points: • The vent hose must be at least 10cm (4 ins) in diameter. • No more than three right-angled bends should be allowed when positioning the vent hose. • Do not distort or constrict the vent hose as this will r ...

• Select correct heat position.

• Set the timer to the correct position (See programme around the timer on fascia panel). • For energy labeling purposes (EN61121:2005) for a cotton dry load, use the maximum load weight for cotton and set the timer to the recommended drying time for cotton dry as specified on the control panel. • The standard cotton programme used at full and partial load is the standard drying programme to which the information in the label and the fiche relate. This programme is suitable for drying normal wet cotton laundry. It is the most efficient progra ...

an open door or window. The best

solution is to connect the vent hose to a permanent connection through a wall or a single glazed window. This is particularly recommended for small, cool rooms. Front venting machines must be converted to extendible rear venting before a permanent connection can be made to the outside. When using a vent hose, remember the following points: • The vent hose must be at least 10cm (4 ins) in diameter. • No more than three right-angled bends should be allowed when positioning the vent hose. • Do not distort or constrict the vent hose as this will r ...

As the colours of the wires in the mains lead of this appliance may not

correspond with the coloured markings identifying the terminals in your plug, proceed as follows:- • The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or by the Earth symbol or coloured GREEN and YELLOW. • The wire which is coloured BLUE must be connected to the terminal which is marked with the letter (N) or coloured BLACK. • The wire which is coloured BROWN must be connected to the terminal which is marked with the letter (L) or coloured RED. If ...

The room must be adequately ventilated to avoid the backflow of

gases into the room from appliances burning gas or any other fuels. This includes open fires. It is important to clean the lint filter after each drying cycle. Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer. Fabric softeners, or similar products, should be used as specified by the fabric softener instruction ...

• Select correct heat position.

• Set the timer to the correct position (See programme around the timer on fascia panel). • For energy labeling purposes (EN61121:2005) for a cotton dry load, use the maximum load weight for cotton and set the timer to the recommended drying time for cotton dry as specified on the control panel. • The standard cotton programme used at full and partial load is the standard drying programme to which the information in the label and the fiche relate. This programme is suitable for drying normal wet cotton laundry. It is the most efficient progra ...

CDA ci522 user guide recommended for: CI921, CI560, TK 180, 796.810, DNCK440EA.

⚠️ Download Safety

The Dryer Manual for installation, use and maintenance (20 pages) is completely safe to download (last scan date: 14/11/2025).

Related PDF Instructions for CDA ci522:

Dryer Equipment: Frequently Requested

Have some Questions about CDA ci522 Device?

Get valuable and actionable advices from other CDA ci522 device users. Describe your problem or question, regarding the using of ci522, in as much detail as possible, and other users will be able to answer you.