HearthStone 8330 Owner's Manual

Manchester Model 8330 Pellet Stove Page 16 of 59 Venting Warning: Ensure your venting system (chimney connector, and chimney) are in good condition and kept clean. The minimum horizontal clearance to vegetation and other exterior combustibles such as mulch is 36” as measured from the center of the outlet or termination cap. This 36” radius continues to grade up to a minimum of 7 feet below the outlet. The longer the vent pipe and more elbows used in the system, the greater the flow resistance. Therefore, we recommend using as few elbows as ...

Manchester Model 8330 Pellet Stove Page 48 of 59 Maintenance Weekly or as Needed Remove ash from firebox 1. Lift burn pot, sweep ashes into ash pan or use an ash vacuum. WARNING! USE OF A REGULAR VACUUM MAY CAUSE A FIRE. Remove ash from ash pan 1. Remove drawer, deposit ashes in proper metal receptacle with closable lid. Clean glass DO NOT USE ABRASIVE CLEANERS ON THE GLASS. 1. Use glass cleaner and soft cloth, or use pellet ash and a water moistened cloth (rub lightly). Monthly Clean Hopper & Auger 1. Remove auger access plate inside hopper (8mm ...

Manchester Model 8330 Pellet Stove Page 22 of 59 Venting INSTALLATION EXAMPLE: EXISTING MASONRY CHIMNEY Installed into an existing masonry chimney with no L Vent liner (chimney must have other approved liner in good condition, and a working clean-out). 3” or 4” L vent is acceptable. 3 or 4” L Vent Approved Liner ...

Manchester Model 8330 Pellet Stove Page 2 of 59 Intentionally Blank ...

Manchester Model 8330 Pellet Stove Page 8 of 59 Components Components and features: Maintenance Tool Heat Exchanger Rake Rod (x2) Control Panel Secondary Hopper Door Ash Pan Screen (below grill) Door Handle Main Hopper Door Burn Pot Firebox Baffle Hopper Door Handle Hopper Door Sensor Sensor Magnet Front Door Burn Pot Pellet Feed Tube Ignitor ...

Manchester Model 8330 Pellet Stove Page 55 of 59 General Issues: Problem Possible Causes Solution Burn pot is overflowing. Burn pot needs cleaning Remove excess ashes, clinkers, and live coals from burn pot Ignition did not occur Clean burn pot Ensure burn pot installed with ignitor hole towards rear Ignitor failure. Service the unit. Dirty stove Preform a Yearly Cleaning (see page 49) Stove feeding pellets without ignition Turn off stove. Dump pellets into ash pan. Restart stove. Burn pot clogs too quickly or pellets are partially burned (less ...