Star CSD-2-H Series Installation And Operation Instructions Manual

1. Load preheated product pouch into dispenser. 2. Dispense product until there is a steady fl ow. 3. Dispense the product into a clean container, and measure the product to verify the dispensed amount. 4. Using a small screwdriver, turn the control dial, located on the back of the unit, clockwise for more product, and counter-clockwise for less product. 5. Repeat steps 3 and 4 until the desired amount is reached. NOTE: This dispenser control is based on a time setting. Variations in product temperature and consistency will affect the dispensed amount. To insure a consist ...

IMPORTANT: WHEN ORDERING, SPECIFY VOLTAGE OR TYPE GAS DESIRED PAGE INCLUDE MODEL AND SERIAL NUMBER OF Some items are included for illustrative purposes only and in certain instances may not be available. Number Per Unit Description and Model Designation Star Manufacturing International, Inc. MODEL Part Number Key Number Double Peristaltic Cheese Dispenser CSD-2-H 1 M2-Z1697 1 BACK M2-Z5080 1 BACK CSD-2NHC, CSD-2RCH, CSD-2RCCH 2 M2-22027 1 TOP BACK ASSY 3 2I-Z1894 2 HINGE INSERT 4 2T-Y5708 2 THERMOSTAT #60T13 ...

1. Load preheated product pouch into dispenser. 2. Dispense product until there is a steady fl ow. 3. Dispense the product into a clean container, and measure the product to verify the dispensed amount. 4. Using a small screwdriver, turn the control dial, located on the back of the unit, clockwise for more product, and counter-clockwise for less product. 5. Repeat steps 3 and 4 until the desired amount is reached. NOTE: This dispenser control is based on a time setting. Variations in product temperature and consistency will affect the dispensed amount. To insure a consist ...

1. Load preheated product pouch into dispenser. 2. Dispense product until there is a steady fl ow. 3. Dispense the product into a clean container, and measure the product to verify the dispensed amount. 4. Using a small screwdriver, turn the control dial, located on the back of the unit, clockwise for more product, and counter-clockwise for less product. 5. Repeat steps 3 and 4 until the desired amount is reached. NOTE: This dispenser control is based on a time setting. Variations in product temperature and consistency will affect the dispensed amount. To insure a consist ...

important operating and maintenance instructions in the manual accompanying the appliance. RETAIN THIS MANUAL FOR FUTURE REFERENCE NOTICE Using any part other than genuine Star factory supplied parts relieves the manufacturer of all liability. Star reserves the right to change specifi cations and product design without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment. Due to periodic changes in designs, methods, procedures, po ...

(800) 807-9054 (314) 781-2777 Parts & Service (800) 807-9054 www.star-mfg.com ...