Clear-Com Encore Instruction Manual

Encore System Installation Instruction Manual 1 - 1 9 THEATRE 2 Figure 1-9: Party Line Theatre Application Example 2 In this example of another typical Theatre installation, the Stage Manager operates a two-channel Main Station, which also powers the system. Several single-channel beltpacks are connected to Channel A. The beltpacks are used by props and scenery people. Communication between these people and the Stage Manager is on Channel A. Several single-channel beltpacks are also connected to Channel B. The beltpacks are used by sound, light board, patch pa ...

Encore System Installation Instruction Manual 1 - 1 INTRODUCTION Congratulations on choosing Clear-Com products. Clear-Com was established in 1968 and remains the market leader in providing intercom for entertainment, educational, broadcast and industrial applications. The ruggedness and high build-quality of Clear-Com products is the industry standard. In fact, many of our original beltpacks and Main Stations are still in daily use around the world. We recommend that you read through this manual completely to better understand how to install your intercom sys ...

Encore System Installation Instruction Manual 1 - 2 8 EFP: Electronic Field Production. An EFP truck contains the necessary audio, video, intercom, and other equipment to create these productions. ENG: Electronic News Gathering. An ENG truck contains the necessary audio, video, intercom, communications, and other equipment to effectively support gathering news and transmitting news reports back to a studio. IFB: The term means "Interrupt Fold Back." A Fold-Back is a monitor system that allows, for example, talent to hear their voices or musicians to hear th ...

Encore System Installation Instruction Manual 1 - 4 channels are required. If multi-channel stations are connected with multi-pair cables, then crosstalk becomes an important issue. Crosstalk is not a factor with single-channel systems or multi-channel systems where each channel is run on its own individual cable to single-channel Remote Stations. While the physical considerations include ease of installation, type of cabling, station location, etc., the electrical considerations are concerned primarily with the capacitance between conductors on the intercom ...

Encore System Installation Instruction Manual 2 - 6 Figure 2-3: MS-702 Jumpers • In the MS-440, MS-704, RM-440, RM-704, SB-440 and SB-704 stations, the jumper is located near the middle of the main circuit board. J11 should be set to ON to enable the option or OFF to disable it. SYSTEM SETUP After connecting the MS-232, MS-702, MS-440, MS-704, RM-440, RM-704, SB-440 or SB-704 Station, perform the following steps to assure that the audio level will be correct at each listening point: 1. Press the Announce button and adjust the stage announce power amplifier fo ...

Encore System Installation Instruction Manual 2 - 6 Figure 2-3: MS-702 Jumpers • In the MS-440, MS-704, RM-440, RM-704, SB-440 and SB-704 stations, the jumper is located near the middle of the main circuit board. J11 should be set to ON to enable the option or OFF to disable it. SYSTEM SETUP After connecting the MS-232, MS-702, MS-440, MS-704, RM-440, RM-704, SB-440 or SB-704 Station, perform the following steps to assure that the audio level will be correct at each listening point: 1. Press the Announce button and adjust the stage announce power amplifier fo ...