Mitsubishi Electric FR-B-750 to 75K Instruction Manual

deceleraiton 12 92 5 { { { { { 519 S-pattern time at a completion of deceleraiton 13 93 5 { { { { { 539 Modbus-RTU commnunication check time interval 27 A7 5 { { { { { 541 Frequency command sign selection (CC-Link) 29 A9 5 { { { { { 542 Communication station number (CC-Link) 2A AA 5 { { { { { 543 Baud rate (CC-Link) 2B AB 5 { { { { { 544 CC-Link extended setting 2C AC 5 { { { { { 549 Protocol selection 31 B1 5 { { { { { 550 NET mode operation command source selection 32 B2 5 { { { { { Parameter Name Instruction Code * 1 Model based Correspondence Table *2 Param ...

7.2.2 FR-B3 series common specifications Control specifications Control method Soft-PWM control/high carrier frequency PWM control (selectable from among, advanced magnetic flux vector control). Output frequency range 0.2 to 120Hz Frequency setting resolution Analog input 0.015Hz/0 to 60Hz (terminal 2, 4: 0 to 10V/12bit) 0.03Hz/0 to 60Hz (terminal 2, 4: 0 to 5V/11bit, 0 to 20mA/about 11bit, terminal 1: 0 to ±10V/12bit) 0.06Hz/0 to 60Hz (terminal 1: 0 to ±5V/11bit) Digital input 0.01Hz Frequency accuracy Analog input Within ±0.2% of the max. output frequency (25° ...

4.4 Before operating the FR-B3 series 4.4.1 Setting the FR-B3 series (advanced magnetic flux vector control) (Pr. 80, Pr. 81, Pr. 89 ) Setting can be made only for FR-B3 series. For explosion-proof certification, the FR-B3 series are tested with the rotation mode under the advanced magnetic flux control after the offline auto tuning has been performed. In the initial setting, the advanced magnetic flux vector control is selected. Always perform the offline auto tuning with the rotation mode before operation. zWhat is advanced magnetic flux vector control? The ...

(6) Modbus registers z System environment variable *1 The communication parameter values are not cleared. *2 For write, set the data as a control input instruction. For read, data is read as an inverter operating status. *3 For write, set data as the operation mode setting. For read, data is read as the operation mode status. Register Definition Read/Write Remarks 40002 Inverter reset Write Any value can be written 40003 Parameter clear Write Set H965A as a written value. 40004 All parameter clear Write Set H99AA as a written value. 40006 Parameter clear *1 ...