Morso 3410 Installation And Operating Instructions Manual

75180400 75180400 75180400 66 Axis for handle 75462700 75462700 75462700 67 Stainless pressure spring 79048600 79048600 79048600 68 Glass fitting 54146261 54146261 54146261 69 Air slider washer 791891 791891 791891 70 Washer 79189400 79189400 79 ...

stalling the flue system for use in a mobile home. • Outside air kit should be installed according to installation guide in the kit. • Intake air piping can be installed through the floor into a vented crawl space or through the wall of the residence to obtain outside air. • Install in accordance with 24 CFR, Part 3280 (HUD). • NOTE: Top sections of chimney must be removable to allow maximum clearance of 13.5’ from ground level for transportation purposes. WARNING: NEVER DRAW COMBUSTION AIR FROM A ...

Note that the flue system must be independently secured and must not rely on the stove for support. The stove must not be connected to a chimney flue serving any other appliance. (Several flues may run up a single chimney stack; use one flueway per appliance). Use a residential type masonry or listed type HT factory-built chimney. High Temperature (H.T.) Chimney Standard UL-103-1985 (2100º F.) for the USA, and High Temperature (650ºC) Standard ULC S-629 for Canada. The internal dimensions of the chimney connector and chimney must not be less than 6 inche ...

replaced if it becomes difficult to close the door or if air starts to leak in around the perimeter of the door, causing the fire to become a little less controllable. A morsø rope gasket kit is available from your stove supplier. 3.3 Cleaning the Stove and the Flue Check for soot above the baffle plate and around the flue outlet every month or so to start with. If the stove suddenly becomes sluggish, check for a soot fall around the flue collar or in the flue/chimney. - at least once ...

Single-wall connectors should be made of 24 gauge or heavier gauge steel. Do not use galvanized connector; it cannot withstand the high-temperatures that smoke and exhaust gases can reach, and may release toxic furnes under high heat. The connector must be 6 inches (150mm) in diameter. If possible, do not pass the chimney connector through a combustible wall or ceiling. If passage through a combustible wall is unavoidable, refer to the sections on Wall Pass- Throughs. Do not pass the connector t ...

FIREPLACE HEARTH INSTALLATION (ALCOVE) USA CANADA A. B. C. D. E. F. - 20’’ 19’’ 11’’ - - - 510 mm. 480 mm. 280 mm. - - SIDEWALL TO UNIT COMBUSTIBLE MANTEL TO UNIT TOP FACING SIDE FACING HEARTH EXTENDING, FRONT HEARTH EXTENDING, SIDE 3410, 3440 and 3450 CLEARANCE REQUIREMENTS ALCOVE INSTALLATION USA CANADA W. D. G. 51’’ 31’’ 48’’ 1295 mm. 790 mm. 1220 mm. MINIMUM ALCOVE WIDTH MAXIMUM ALCOVE DEPTH ALCOVE CEILING ABOVE STOVE TOP 3410 and 3450 3440 CLEARANCE REQUIREMENTS ALCOVE INSTALLATION USA CANADA W. D. G. 35’ ...

authorization to approve your installation. You should discuss the installation with them before beginning. Please ask your dealer for further information. Do not connect to any air distribution duct or system. Important: If the installation instructions are not followed carefully, it may cause dangerous situations like chimney - and house fires. Follow the instructions carefully and do not deviate from them as it may cause injuries to people or property. 1.1 Checking loose parts in ...