Takex FS-2000E Instruction Manual
Text of the manual
Flame sensor FS-2000E is designed to detect ultraviolet rays contained in flames, and to initiate an alarm.
In addition to alarm sound, FS-2000E is equipped with form C (N/C, N/O.) output, to meet professional application.
Also, memory LED enables you to find out the initiated sensor out of a series of sensors.
Area a
Objects to be detected
2
ATTENTION
3
DO'S AND DON'T'S
●
●
●
This sensor is designed to detect ultraviolet rays contained in
flames, and to issue a signal.
This unit is neither fire detector nor heat detector nor smoke
detector.
TAKEX is not responsible for damage, injury or losses by fire,
accident, calamity, Acts of God
Locate the installation site.
(Ref : 3, DO'S AND DON'T'S and 7,
DETECTION AREA)
Slide the release lever to detach the
sensor unit.
※To make the exposed wiring, break
the knockout and insert wires into
the wire lead.
※Sensor head can
be adjusted
ahead with 4
steps. (Ref : 7,
Detection area)
●When sensor unit is
detached, wrap
Alarm (Basic action)
Alarm sound (buzzer)
(1) Operation
(2) Mode setting
Alarm memory
6
OPERATION AND FUNCTION
SET
ON
OFF
AUTO
(ON)
OFF
Application and installation
●For the quick detection of the
flame of lighter / match at no
smoking zone.
●When above setting is not stable.
●For the detection of the fire at
smoking zone
●At the window etc. wh
1. Turn power on.
2. Ignite a lighter etc. within detection area for more than the set time.
3. After the set time, an alarm output is issued, buzzer sounds intermittently and
LED blinks. (Alarm action)
4. 2 sec. after the flame goes off, alarm output ends. 10sec. after the flame
goes off, other alarm actions ends. (Check the alarm output by connecting
a dev
