HP Spectre Maintenance And Service Manual

The wide-range input feature of the computer permits it to operate from any line voltage from 100 to 120 volts AC, or from 220 to 240 volts AC. The 3-conductor power cord set included with the computer meets the requirements for use in the country or region where the equipment is purchased. Power cord sets for use in other countries and regions must meet the requirements of the country or region where the computer is used. Requirements for all countries The following requirements are applicable to all countries and regions: ● The length of the power cord set mus ...

(includes processor and replacement thermal material). 689957-001 System board for use only with computer models equipped with an Intel 1.9GHz processor (includes processor and replacement thermal material). 689958-001 System board for use only with computer models equipped with an Intel 2.0GHz processor (includes processor and replacement thermal material). 689959-001 (15) Heat sink 689938-001 (16) Solid-state drive 128-GB, SSD 6 ...

Item Component Spare part number (1) Display bezel 692888–001 (2) 13.3" HD, WLED, BrightView display panel 692891–001 (3) Webcam/microphone module 689965-001 (4) Display cable 692889–001 (5) Hinge covers: Hinge covers 689940–001 Side hinge covers 689940–001 (6) Hinge brackets 689940–001 (7) Display enclosure 694726–001 Display assembly subcomponents 17 ...

the base enclosure. 3. Separate the bottom enclosure from the unit at the rear edge and remove the bottom enclosure. NOTE: To remove the bottom enclosure, use a thin, non-conductive tool such as the HP Tool Shroud separator. This tool is available on the HP website. 28 Chapter 4 Removal and replacement procedures ...

Pixel resolution Pitch 0.197 mm × 0.197 mm Format 1366 × 768 Configuration RGB vertical stripe Backlight LED Character display 80 × 25 Total power consumption 2.0 W Viewing angle ±65° horizontal, ±50° vertical (typical) 13.3-inch display specifications 67 ...

CAUTION: This computer does not have user-replaceable parts. Only HP authorized service providers should perform the removal and replacement procedures described here. Accessing the internal part could damage the computer or void the warranty. Preliminary replacement requirements Tools required You will need the following tools to complete the removal and replacement procedures: ● Flat-bladed screwdriver ● Magnetic screwdriver ● Phillips P0 and P1 screwdrivers Service considerations The following sections include some of the considerations that you mu ...

Remove the display panel (3). 13. Remove the adhesive tape from the display panel cable connector (1). 14. Disconnect the display panel cable connector (2) from the display panel (2). 15. Remove the panel cable from the clips on the left edge (1), and then loosen the cable from the adhesive tape (2). 54 Chapter 4 Removal and replacement procedures ...