Roger PR302 Installation Manual

PROXIMITY & PIN READER FIRMWARE VERSION 119.0 Installation Manual ...

simultaneously or exclusively. PR302 has a built-in proximity reader, 12 digit keypad and three LEDs. Controller offers three inputs, one relay output and two transistor outputs. Inputs and ...

activated. Note: The main advantage of networked system equipped with CPR is that events which have been occurred on controllers are instantly transferred to remote “secure” buffer in CPR and that CPR continuously ...

9 XM-8 module The lift control module, floors 9-16. 10 Reserved 11 Reserved 12 Reserved 13 Reserved 14 Reserved 15 Reserved Note: If controller is configured for operation with remote Wiegand type reader instead of PRT terminal no XM modules nor PSAM-1 can be connected to ...

Momentary Type Selection Input is dedicated to be connected to button which when pressed will turn controller to specified T&A Mode. The T&A mode which will be set after input is triggered is declared by installer for each input line individually. The new T&A Mode is active till nearest user identification, if du ...

earlier by using any valid identifier (Card/PIN) registered in system. Alarm on controller can also be cleared remotely from PC. When the [ALARM Output] has been programmed to signalize more than one alarm condition, only t ...

can be achieved by option Access disabled in OFF mode. An ON/OFF mode of controller can be controlled in few listed below ways: • manually by SWITCHER or MASTER user, • by external input line configured as ON ...

operation: Door Mode Description Normal Door lock is activated after controller decide to grant access. Unlocked Door lock is continuously energized, door can be opened by any unauthorized person. Conditi ...

• by manual command entered from controller's keypad, • by activation of input line. If option Terminals ID=0 and ID=1 have the same T&A Mode is active events registered on terminal ID=0 have the same T&A status a as events registered on terminal ID=1 (no matter if event was registered on t ...

Controller offer three LEDs marked as ON/OFF, OPEN and SYSTEM. An ON/OFF led is a bicolor type and may be set to green or red. When set to green it signalize that controller is in ON mode, when is set to red it signalize that controller is in OFF mode. Led OPEN (green) signalize that relay output is activated what u ...