HP JG221A Installation Manual

© Copyright 2011 Hewlett-Packard Development Company, L.P. No part of this documentation may be reproduced or transmitted in any form or by any means without prior written consent of Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. HEWLETT-PACKARD COMPANY MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Hewlett-Packard shall not be liable for errors contained herein or for incidenta ...

NOTE: HP recommends that you perform basic configuration for your switch before connecting it to the network. Connecting your switch to the network through twisted pair cables The 10/100/1000Base-T ports of the A3100 v2 Switch Series use RJ-45 connectors and support MDI/MDI-X auto-sensing. Use category-5 or higher twisted pair cables to connect the Ethernet ports of your switch to the network. To connect your switch to the network through twisted pair cables: 1. Make a straight-through or crossover Ethernet cable as needed. 2. Plug one end of the twisted ...

A3100 v2 SI Switch Series technical specifications Table 10 A3100 v2 SI Switch Series technical specifications Item A3100-24 v2 SI A3100-16 v2 SI A3100-8 v2 SI Dimensions (H × W × D) 43.6 × 440 × 160 mm (1.72 × 17.32 × 6.30 in) 43.6 × 360 × 160 mm (1.72 × 14.17 × 6.30 in) 43.6 × 230 × 160 mm (1.72 × 9.06 × 6.30 in) Weight ≤ 3 kg (6.61 lb) Fixed ports 24 × 10/100Base-TX auto-sensing Ethernet ports 2 combo interfaces (numbered 25 and 26) 16 × 10/100Base-TX auto-sensing Ethernet ports 2 combo interfaces (numbered 17 and 18) 8 × 10/100Base- ...

workbench, attach the four rubber pads to the switch bottom first. Figure 19 Rubber pad appearance 1 (1) Rubber pad Installing the switch into the 19-inch rack CAUTION:  Ensure a clearance of 1U (44.45 mm, or 1.75 in) between equipment for heat dissipation.  For a switch with a depth greater than 300 mm (11.81 in), the front mounting brackets only secure the switch rather than bear its weight. To mount this switch to a rack, you need to use front mounting brackets and ot ...