AGA AIMS EC Owner's Manual

Operating Distance The Handset will only operate in the same room as the appliance and up to a maximum distance of 4 metres from the appliance. If out of recommended operating range, the handset may show “OFFLINE”. Move handset back to within the recommended distance and the handset should correct itself. See note at foot of page for “Handset to Base Unit Signal Check”. Cleaning The Handset should be wiped clean using a soft clean cloth. Do not use abrasive cleaning products or submerge the Handset in water. Batteries The Handset is fitted with four 'AAA' batteries. ...

13 The following points are intended to help during the period of change-over from a previous cooker. The Aga book and the new user guide video provide a very useful introduction to the cooker. After the Aga has been assembled When first used the Aga will emit an odour for a short while. This is simply due to the protective oil burning off the hotplates. Wipe the inside of the lids whilst the Aga is heating up to avoid a film of oil being deposited on the inside of the lids. Also, condensation may occur on the top plate and front plate whilst the Aga is heating up. This shoul ...

THIS APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING PLATE, WHICH IS SITUATED BEHIND THE LOWER LEFT HAND DOOR. A 13 amp 230v ~ 50 Hz fused electrical supply is required adjacent to the appliance. External wiring to the unit must be installed using a 3 core silicon - SIHF insulation cable and in accordance with the current wiring regulations and any local regulations which apply. The method of connection to the mains electricity supply must facilitate complete electrical isolation of the appliance, preferably by a fused double pole switch, hav ...

See Figs. 7, 8, 9 & 10 Pre-site visiting will have determined where and how the layout of the oven vent pipework should be designed and installed. It is then necessary to check that the pipework design and the pipework resistance are within the parameters possible. The appliance oven venting pipe can be achieved, up to a maximum length of 6 metres, through an outside wall or unused flue etc. Great care must be taken in all-timber houses. If the oven vent pipe passes through combustible material, there must be an airgap of at least 25mm around the pipe and preferably wrappe ...

Operating Distance The Handset will only operate in the same room as the appliance and up to a maximum distance of 4 metres from the appliance. If out of recommended operating range, the handset may show “OFFLINE”. Move handset back to within the recommended distance and the handset should correct itself. See note at foot of page for “Handset to Base Unit Signal Check”. Cleaning The Handset should be wiped clean using a soft clean cloth. Do not use abrasive cleaning products or submerge the Handset in water. Batteries The Handset is fitted with four 'AAA' batteries. ...

Fig. 18 Indicates that the cooker is operating automatically (AIMS) or manually (according to switch position on main Aga control panel) Icons indicating the current time and day This icon shows if the vent fan is on or off 19 DESN 515272 This will only show if the Holiday mode has been set Fig. 19 THE SETTINGS DATE/TIME SCREEN DESN 515273 Press the button to move between the date and time. Press + or - to alter date and time settings. Press the button to confirm the settings and move to the next action Press the button to activate this screen Pr ...

DESN 512403 DESN 512404 Fig. 15a Fig. 15b When using the oven shelves for the first time follow Figs. 15a - 15d. 15 ...

Press the fan button on the handset, the vent fan symbol should show on the handset screen. The oven vent fan should operate and the fan oven neon on the control panel should illuminate. Press the fan button again and the fan should go off. In the event of the handset not communicating with the base unit refer to page 22 of these instructions “Handset to base unit signal check” Fig. 3 OVEN THERMOCOUPLE Fig. 4 NOTE: On AIMS controlled cookers the thermostat phial (probe) has been replaced by an oven thermocouple sensor, which is fitted to the PCB on the co ...