KitchenAid KFRS271TSS Technical Education

The Model/Serial Number label locations are shown below. A. Model/serial number plate A A. Model/serial number plate A On freestanding models, the model/serial number rating plate is located inside the grill cabinet on the right-hand cabinet side. See the following illustration. On built-in models, the model/serial number rating plate is located on the right-hand side of the grill. See the following illustration. ...

Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to do so can result in death or electrical shock. WARNING 1. Plug into a grounded 3-prong outlet. Style 2 - Built-In Outdoor Grill Installation Excessive Weight Hazard Use two or more people to move and install grill. Failure to do so can result in back or other injury. WARNING Unpack grill. Remove all packaging materi- • als and remove grill from carton. Move grill close to desired outdoor loca- • tion. Open the ho ...

B. Foam wrap A B 4. Replace the grill grates. 5. Place warming shelf on brackets as shown. A. Warming shelf brackets B. Warming shelf A B A 6. Attach condiment shelf to the inside of the left cabinet door. A. Attachment holes B. Condiment shelf A B 7. Dispose of/recycle all packaging mate- rial. Explosion Hazard Securely tighten all gas connections. If connected to LP, have a qualified per- son make sure gas pressure does not exceed 11” (28 cm) water column. Examples of a qualified person include: Licensed heating personnel, authorized gas company personnel, and au ...

We have provided many important safety messages in this manual and on the appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instru ...

1. Turn off and disconnect the gas supply going to the grill. 2. Remove the infrared burner ignitor from the grill (see step 2 on page 4-4 for the procedure). 3. Remove the screw from the rear access panel and remove the panel. 7. Remove screws holding infrared rotisserie burner to hood assembly. Rear Access Panel Screw Disconnect Gas Line Here 4. Disconnect the gas line fitting going to the infrared burner. Screws Screws Infrared Rotisserie Burner Rear Of Unit Hood Assembly Rear Of Unit 6. Remove twelve screws holding rear panel to hood assembly. 5. ...

drawer control. Control Wires Electrical Control Box 3. To remove heating element. a) Unplug grill or disconnect power. b) Pull the warming drawer out to the fully extended position. c) Push down or pull up release tabs on each drawer slide. Drawer Slide Release Tab d) Remove warming drawer from drawer slides in warming drawer assembly. e) Remove tank storage drawer to right of warming drawer using the same proce- dure as removing warming drawer. f) Remove screws from electrical access cover on right side of warming drawer assembly. Screws Electri ...

Burner 1. Do not lean over the grill. 2. Remove the manual lighting extension (see following illustration) and attach a match to the split ring. Freestanding grills - right- hand cabinet door Built-in grills - right-hand side fange 3. Strike the match to light it. 4. Gently hold the lit match close to the rotis- serie burner. A. Lighting extension B. Rotisserie burner A B 5. Push in and turn the control knob to LITE/ HI. Hold this knob in for 10 seconds after the burner is lit. IMPORTANT: If the rotisserie burner does not light immediately, turn ...