ABB ACS310 Manuals

ACS310, ACS320, ACS350 and ACS355 MUL1-R4 Installation Instructions 1 WARNING! Before installing MUL1-R4 option, read the safety instructions and mechanical and electrical installation 1 instructions in the drive User’s Manual. Follow the instructions when installing, operating and servicing the drive. If ignored, physical injury or death may follow, or damage may occur to the drive, motor or driven equipment. M4×8 2 Note: You cannot lead the Safe torque off (STO) cable through the gland plate in the ACS355. 2. Fasten the gland box frame to wall with four M4 screws (not included). 1. Fasten the gland box frame to drive with two M4×16 screws and one M4x8 screw. Note: The M4×8 screw is already installed in the drive. 4 5a 5b 3 5. Install the clamp (5a) for the control cable, or if cables are run in conduits, replace all clamps with suitable glands (not included). Run cables through the clamps and tighten. Strip cable ends. Fasten the grounding conductor (PE) of the input © 2010 ABB Oy. All Rights Reserved. 3AUA0000025916 Rev. C / 2010-01-25 3. If control cables or fieldbus option modules will be installed, remove the detachable lid (3) from the gland box cover. 4. With any fieldbus option module except FRSA-00, install the option grounding plate to the gland box frame. See Mechanical installation in the drive manual. g g ( ) p power cable and the twisted shield of motor cable under the grounding clamps (5b). Connect the conductors to appropriate terminals. See Electrical installation in the drive manual.

Quickstart Guide ABB PLC and drives integration using Modbus RTU

Short User’s Manual ACS310 Safety Table of contents Mechanical installation Electrical installation Start-up and control with I/O all-guides com

ABB drives User’s manual ACS310 drives Aotewell Ltd www.aotewell.com Industry Automation HongKong|UK|China sales@ aotewell.com + 86-755-8660-6182