ADLINK Technology DAQ-2010 Manuals

ADLINK Technology DAQ-2010 Operation & user’s manual (73 pages)

• Identifier: id-1536916
• Brand: ADLINK Technology
• Device: Data Loggers
• Type: Operation & user’s manual, PDF
• Key Aspects: Updates and Software Features, Safety Precautions, Network Configuration Instructions
• UPD Date: 11.04.2026
• Source File: 1464360.pdf
• Pages: 73
• Description: Instruction booklet for the ADLINK Technology DAQ-2010. It outlines the setup and assembly reference, software configuration, error codes, system setup.

Key Pages and Contents:

• 14 • Installation

  2.4 PCI Configuration 1. Plug and Play: As a plug and play component, the card requests an interrupt number via its PCI controller. The system BIOS responds with an interrupt assignment based on the card information and on known system parameters. These system parameters are dete

• Signal Connections • 19

  In single-ended configurations, more electrostatic and magnetic noise couples into the single connections than in differential configurations. Therefore, the single-ended connection is not recommended unless minimal wire connections are necessary. 3.2.3 Differential Measure

• 34 • Operation Theory

  (PSC_Counter=2, retrig_no=3) Acquisition_in_progress Scan_start ADCONV Acquired & stored data (6 scans) Operation start Trigger Post Scan Count 2 1 0 1 0 1 0 2 2 Figure 18: Post trigger with re-trigger 4.1.4.3 Bus-mastering DMA Data Transfer PCI bus-mastering DMA is necess

• 58 • Operation Theory

  SSI timing signal Functionality SSI_TIMEBASE SSI master: send the TIMEBASE out SSI slave: accept the SSI_TIMEBASE to replace the internal TIMEBASE signal. Note: Affects on both A/D and D/A operations SSI_AD_TRIG SSI master: send the internal AD_TRIG out SSI slave: accept the