Detech GATE WL Manuals

DeTech 1 GateWL REV: 02/08/2018 GATE WL Double tented technology via bidirectional radio Gate WL is a double tented technology sensor, with a 140° x 15° coverage. Ideal for the protection of gaps, doors, windows, corridors and balconies. Caratteristiche tecniche ➢ Absorption at rest: 26 uA. ➢ Installation height: up to 4 m. ➢ Adjustable range. ➢ Adjustable relevation sensibility. ➢ Microstrip microwave 10.525 gHz. ➢ Flicker-free board ➢ Sealed optical. ➢ 140° x 15° for 4 m coverage ➢ Power supply: 3,6v- n.1 lithium battery ,3v6 mod. ER14505 cabled AA 2,4Ah. ➢ 3 years of life (at standard use) ➢ Radio Freq.868MHz-FM. ➢ Encrypted code. ➢ Anti tampering protection. ➢ Radio supervision. ➢ Visual indication of low battery ➢ Selectable detection circuit. ! WARNING: Before every trial, connect the sensor to the receiver 1. Installation guide Gate WL è is designed to protect gaps like corridors, windows and balconies. It has to be placed horizontally in the middle and on the highest area of the place you need protection on. Remove the upper lid, remove the board pushing on the finger, carve the preprinted holes on the bottom and secure it with the screws and the pieces to protect with the lens pointing downwards. Do not point the sensor upwards. Its coverage in width is twice its installation height.. Ex: if placed in the middle of a window 1m tall, its coverage in width will 2 m. 2.BATTERY INSERTION Remove the board and connect the battery to the circuit through the connector, positioned on the back of the board and put it in the battery carrier on the D bottom. Wait 2 minutes for the auto-calibration. The GREEN and RED LEDs will blink alternatively 3. ACQUISITION The acquisition of the sensor in the system takes place when a Tamper alarm is generated (by releasing the Tamper button) or setting the battery in “acquisition” mode. 4RADIO COVERAGE TEST When the battery is disconnected, push the Tamper button and connectthe battery. When the LED will blink, drop the Tamper button. The GREEN LED suggests a good signaling, when the GREEN and RED LEDs blink, the wireless signal is not fit, with no blinking the signal is absent. To end the Test, push the Tamper or wait for 4 minutes. 5. ADJUSTMENT Adjust the range of the microwave through the dedicated trimmer. Select, if necessary, the high sensitivity relevation mode for open gaps that can be crossed on the run ( sens jumper inserted) To disable, if requested, the LED display,insert the LED jumper. Close the lid, hooking it on the battery side, and closing it with a screw. Once the lid is closed, the TAMPER will activate; The validation of the correct closure of the tamper is given by an alternating blinking (lasting for a couple of seconds) of the GREEN and RED LEDs. Repeat this operation if necessary. ! WARNING: Before every trial, connect the sensor to the receiver 6. WALK TEST Antenna Finger Tamper Trimmer regulation MW