ENSA ENSA-PS1 Manuals

ENSA-PS1 PASSIVE INFRARED OUTDOOR MOTION ACTIVATED SWITCH INSTRUCTION MANUAL www.ensalife.com Thanks for choosing the ENSA-PIR1 Passive Infrared Sensor! This product is an automated motion activated switch. It is based around a high sensitivity pyroelectric detector, light sensor and control electronics. The switch will turn on when it detects movement inside the detection area and stay on until a preset time has elapsed. The sensor will only switch the load on when the measured LUX level is below a set threshold. For installation only by a qualified Electrician – IP65 RATED FOR OUTDOOR USE SPECIFICATIONS: AC Input: 220-240VAC Detection Range: 180° Power Frequency: 50Hz Detection Distance: 12m max(<24℃) Ambient Light: <3-2000LUX (adjustable) Working Temperature: -20~+40℃ Time Delay: Min.10sec±3sec Working Humidity: <93%RH Max.7min±2min Power Consumption: approx 0.5W Rated Load: Max.1200W Installation Height: 1.8-2.5m 300W Detection Moving Speed: 0.6-1.5m/s FEATURES:  Built in light sensor which can be set to detect between 3 lux (“moon” position) and 2000 lux (“sun” position).  Time–Delay before load switch off is adjustable between 10 seconds and 7 minutes.  Time delay before switch off is automatically reset when the sensor detects movement, even if the load is still on. This means that intermittent movement will keep the load on.  LUX sensing is disabled while the load is on – This stops switched lights from triggering the lux sensor and turning themselves off.  Wide angle PIR Fresnel lens can be tilted to the best position for optimum sensitivity. INSTALLATION ADVICE: To ensure the best detection range, mount the sensor in a position where people will walk across the detection field, rather than toward it Good sensitivity Poor sensitivity