Extron electronics DSC 301 HD Manuals

1 Mounting and Cabling Step 1 — Mounting Turn off or disconnect all equipment power sources and rack mount the DSC 301 HD unit with either an optional shelf mounting brackets (RSU 126 or 129, RSB 126 or 129) or optional furniture mounting brackets (MBU 125); see figures 1 and 2 at right. When rack mounting, an optional rack false face plate (RFF 052) can be fitted on top of the low profile DSC, improving the overall look within the rack. Step 2 — Connecting inputs Connect inputs from video sources to the applicable connectors marked “Inputs”: b Composite video, c RGB, R-Y, Y, B-Y, d HDMI (with or without embedded digital audio). Connect inputs from analog audio sources to the TRS inputs e. Step 3 — Connecting outputs Connect a suitable output display device to the connector marked “Output” (see f above) for HDMI output with embedded audio. Step 4 — Connecting control devices RS-232 — For serial RS-232 control, connect a host computer or control system to the 3-pole captive screw connector g. RS-232 protocol (default values): 9600 baud, 1 stop bit, no parity, 8 data bits, no flow control. USB — Connect a host computer or control system to the front panel mini USB port for configuration and control via Extron Configurator software. Step 5 — Connecting power DC power connector — Plug in a 12 VDC, 1A max power source into this 2-pole captive screw connector a. DSC 301 HD • Setup Guide The Extron DSC 301 HD Digital Scaling Converter is a scaling product that accepts the most common video signal formats to be processed, scaled, and output as HDMI. This setup guide allows an experienced user to easily and quickly set up and configure a DSC 301 HD using step by step instructions. It covers how to perform basic operations using the front panel controls and selected Simple Instruction Set (SIS™) commands. NOTE: For full installation, configuration, menus, connector wiring, and operation details, see the DSC 301 HD User Guide, available at www.extron.com Universal Rack Shelf Front false faceplate uses 2 screws. 1/2 Rack Width Front False Faceplate Use 2 mounting holes on opposite corners. (2) 4-40 x 3/16" Screws RFF 052 1.0A MAX POWER 12V 1 VIDEO RGB/R-Y,Y,B-Y HDMI DSC 301 HD AUDIO 2 3 1 RS-232 Tx Rx G 2 3 INPUTS OUTPUT REMOTE 1.0A MAX POWER 12V 1 VIDEO RGB/R-Y,Y,B-Y HDMI DSC 301 HD AUDIO 2 3 1 RS-232 Tx Rx G 2 3 INPUTS OUTPUT REMOTE DSC 301 HD 4 3 1 2 6 7 5 Installation Rear Panel Features Power and video input connections Output and control connections a DC power connector b Composite video connector c RGB, R-Y, Y, B-Y via 15-pin HD connector d HDMI connector e Audio 3.5 mm TRS (tip-ring-sleeve) connectors f HDMI connector g RS-232 captive screw connector MBU 125 Mounting Bracket #8 Screw (4) Places Each Side Mounting Screws (2) Places Each Side Figure 1. Rack mount Figure 2. Furniture Mount

User Guide DSC 301 HD Digital Scaling Converter 68-2338-01 Rev. B 03 16 Scalers and Signal Processors