Fluidwell F115-P Manuals

Fluidwell F115-P Manual  (52 pages)

• Identifier: id-1789461
• Brand: Fluidwell
• Device: Measuring Instruments
• Type: Manual , PDF
• Key Aspects: Device Configuration Guide, Software Installation Instructions
• UPD Date: 21.03.2026
• Source File: 1750813.pdf
• Pages: 52
• Description: Essential instructions for the Fluidwell F115-P. The manual details hardware instructions, product safety, regulatory notices, system configuration.

Key Pages and Contents:

• The F115-P is suitable for use with flowmeters which have a reed-switch. To avoid pulse bounce

  from the reed-switch, it is advised to select REED LP – low-pass filter (read chapter 3). Fig. 21: Terminal connections - Reed-switch signal input (typical) NAMU

• Mounting, electrical installation, start-up and maintenance of this device may only be

  carried out by trained persons authorized by the operator of the facility. Persons must read and understand this manual before carrying out i

• Fig. 6: GRP enclosures - Dimensions

  75 mm (2.95") 130 mm (5.12") 112 mm (4.40") 60 mm (2.36") 120 mm (4.72") HD HK HK back box: (flat bottom) HE HF HG HH D=12mm 12mm 12mm 24mm 24mm 36mm 36mm 14mm 17mm 22,5mm 30mm 30mm D=16mm D=20mm 0.9" D=22mm (0.866") 22,5mm 25mm 25mm D

• Safety instructions .................................................................................................................................3

  Disposal of electronic waste ............................................................................

Fluidwell F115-P Operation manual (48 pages)

• Identifier: id-1592079
• Brand: Fluidwell
• Device: Measuring Instruments
• Type: Operation manual, PDF
• Key Aspects: Step-by-Step Setup Guides, Periodic Maintenance Tasks
• UPD Date: 20.05.2026
• Source File: 1588635.pdf
• Pages: 48
• Description: Instruction guidebook for the Fluidwell F115-P. This manual details device safety checks, setup validation, system setup, safety protocols.

Key Pages and Contents:

• OPERATOR INFORMATION AND FUNCTIONS

  In general, the F115-P will always function at Operator level. The information displayed depends upon the SETUP-settings. All pulses generated by the connected flowmeter are measured by the F115-P in the background, whichever screen r

• Fig. 15: Configuration example 2 Intrinsically Safe.

  TERMINAL CONNECTORS F100-series HAZARDOUS AREA Ci = 17nF 3 4 9 10 11 12 14 13 Common ground Common ground Common ground Common ground Common ground Signal Signal TOTAL OF ALL CONNECTED APPARATUS MAY NOT EXCEED MINUS 17n

• Below, an overview of the F115-P specific variables; other common variables are described in

  the standard table.  All numbers are decimal numbers, unless otherwise noted.  The following variables of the standard table

• Terminal 03-04; negative total - transistor or relay output R2:

  This output is switched in case the calculated accumulated total counts down. Terminal 05-06; transistor or relay output R1: This output is a pulse output. With SETUP 7, the function of this output is set. The