HIRSCH AEB8 Manuals

HI LO 1 Line Module S S S S HI LO S HI LO S HI LO S HI LO S XA1 XA2 XA3 XA4 XA5 XA6 XA7 XA8 TM Setup AEB8 Quick Installation Expansion Board Interface Cable Connector (EBIC3 or EBIC5) Address Jumpers stranded, shielded twisted pair Alarm Input Connectors (XA1 - XA4) Alarm Input Connectors (XA5 - XA8) No more than 2 AEB8s can be installed in the M2, M8, M64, MSP-8R, or MSP-64R. The M16 cannot accommodate an AEB8. There are two jumper positions in the middle of the board which control board addressing: Jumper Addresses J1 1 - 8 (factory default for first AEB8) J2 9 - 16 (default for second AEB8) TM 1900 Carnegie Ave. Bldg. B Santa Ana, CA 92705-5520 (949) 250-8888 www.hirschelectronics.com rev. 10/00 Testing After installing the board, you can test it by following this procedure: 1. Attach a printer to the Controller or make sure the Controller is attached to a SCRAMBLE*NET PC. 2. Power the system up by first connecting the AC power, then the standby battery. 3. The system goes through its self-test. You should see this information printed out at the local printer. Under the Configurations section, you should see this: Expansion Inputs = 8 if one AEB8 is installed and Expansion Inputs = 16 if two AEB8s are installed. Under the Options section, you should see this line: AEB8-1 if one AEB8 is installed and AEB8-2 if two AEB8s are installed. 4. Use Command 88*2 from the ScramblePad to request the Max Users and Options information, or use Host PC software. 5. If the correct information doesn’t appear on the printouts, power down the Controller and recheck the EBIC connections, then retry the test procedure. If it still doesn’t work, contact Hirsch. The AEB8 is an 8-input Alarm Expansion board where each input is supervised like the inputs on the controller board. A Line Module is required for each input. Line Module shield (terminate at controller only; float at line module)