Intermatic PG1000 Manuals

INSTALLATION INSTRUCTIONS and OPERATIONS MANUAL TURN OFF POWER TO THE ELECTRIC SERVICE OR PANEL AND TO EQUIPMENT TO BE PROTECTED BEFORE INSTALLING ANY SURGE PROTECTION DEVICE. ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRI- CIAN AND SHOULD COMPLY WITH THE NATIONAL ELECTRIC CODE AND LOCAL ELECTRIC CODES. CAUTION: HARDWIRED SURGE PROTECTION DEVICES PG 220 - 440 SSeries PG1000 - 11500 SSeries INSTALLATION: 1. Test and verify system voltage to assure proper model selection of Surge Protection Device (SPD). Refer to the wiring diagrams, configurations and volt- ages on page 2 for additional information. 2. Turn Power OFF. 3. Select a position in the load center or equipment panel that will require the shortest length of wire lead for connection. If installing on a breaker panel, the dis- tance from the main breaker or input lugs to the con- necting breaker is not as important as maintaining short wire lead lengths. 4. Determine the path of the lead wires making sure to avoid sharp 90 degree bends. Attempt to use 2” or larger bends. 5. Remove the knockout from the load center or equipment panel that best suits positioning of the SPD for optimum location. 6. Mount the SPD to the panel or an adjacent wall. If the mounting position prevents the direct connection of the nipple to the load center or equipment panel, a Suitable For Use on a Circuit Capable of Delivering Not More Than 200,000 rms symmetrical Amperes. DO NOT OPEN - contains no serviceable parts INSTALLATION INSTRUCTIONS and OPERATIONS MANUAL PG20-40 SERIES - V.11-03 short piece of conduit or flexible conduit such as “sealtite” must be used to comply with the National Electrical Code and local codes. 7. Twist or ty-wrap lead wires to eliminate any space or gaps between them. Pass the wires through the selected knockout and secure the SPD. 8. Cut each wire lead to the proper length. DO NOT coil extra wire length. Model PG40-480-3D Other models and voltage configurations will appear slightly different