Mania MEGA-LUX Manuals

INSTRUCTIONS PORTABLE MINI LED FLOODLIGHT MEGA-LUX COMPONENTS • LED floodlight • USB cable TECHNICAL SPECIFICATIONS • Input voltage: 5 V • Luminous flux: 400 lm • Material: ABS • Light emitting angle: 120 degrees • Product weight: 250 g • Product size: 135 × 100 × 40 mm • Ingress protection rating: IP44 • Color temperature 6,500K (cold white) • Power: 20 W • Working time: 8–12 hours • Charging time: 4–6 hours • Battery power: 2× 18650 battery / 4× AA battery • Mode: full brightness / low brightness / flashing COMPONENTS (1) Battery cover (2) Battery compartment (3) Adjustable handle (4) Charging port cover (5) Power button (6) Indicator light (7) Charging input port (8) USB output port OPERATION INSTRUCTIONS NOTE: Before using the floodlight for the first time, insert fully charged rechargeable batteries or 4 new AA batteries. 1. To adjust the angle of the floodlight, pull on the handle, and set it to one of the seven detent positions. 2. Press the power button on the back to select from four operating modes: high, low, flashing, and OFF. 3. When finished using the floodlight, store indoors and away from children. CHARGING INSTRUCTIONS CAUTION! Do not leave the floodlight unattended while charging. Charging should be done by adults only. WARNING! Charge on a non-flammable surface in a well-ventilated area. Do not use the floodlight while it is being charged. NOTE: Before using the floodlight for the first time, fully charge the batteries. 1. Open the charging port cover on the back of the floodlight and plug the micro USB connector on the supplied USB cable into the charging input port. Plug the other end of the cable into a USB port of a computer or any other USB power source or adaptor to begin charging. 2. The charging indicator light will turn on. 3. The time required to fully charge the rechargeable batteries is approximately 4–6 hours. When charging is complete, disconnect the USB cable from the floodlight and power source. Close the charging port cover. NOTICE: Do not leave the rechargeable batteries in a discharged state. Charge the batteries every 3 months if the floodlight is not in use. This will keep the batteries from wearing down. Do not charge the floodlight at temperatures below 4 °C. CHARGING USB DEVICES 1. Verify that the floodlight is fully charged, or that new regular batteries are inserted. 2. Open the charging port cover and plug the USB cable of the device you wish to charge into the USB output port. 3. Plug the other end of the USB cable into the device to begin charging. 4. When charging is complete, disconnect the USB cable from the device and the floodlight. 5. Recharge the floodlight batteries or insert new regular batteries. INSERTING THE BATTERIES NOTE: The floodlight can work on two types of batteries (4× AA battery or 2× 18650 rechargeable battery) 1. Unplug the USB cable from the floodlight (if connected). 2. Remove the battery cover on the backside of the floodlight. 3. Insert the batteries and mind the correct polarity. 4. Close the battery cover. IMPORTANT • Only use the included USB charging cable. Other USB cables may damage the unit or cause a fire. • Do not submerge the unit. • Do not operate in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. • People with pacemakers should consult their physician before use. Electromagnetic fields in proximity could cause pacemaker interference or failure. • The floodlight is not a toy. Keep out of children’s reach. • The floodlight works on battery power. Batteries must be recycled or disposed of properly. Do not crush, heat above 60 °C, or incinerate. WARRANTY The warranty is valid for 24 months. You can claim it from DFVU d.o.o., Liparjeva 6a, 1234 Mengeš, Slovenia, for a replacement product or a refund. Send us your order number and purchase date in the email, which is available by clicking on our logo in the bottom right corner. The product has a lifetime of 24 months from the date of collection. WEEE disposal and recycling symbol. The WEEE symbol is attached to the product in compliance with the EU directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). It is intended to deter the improper disposal of this product and to promote reuse and recycling.