Markilux 6000 Manuals

7061029 Folding-Arm Cassette Awning markilux 6000 Fitting Instructions 1 13/01/10 1. Fitting the mounting fixtures 1.1 Fitting height BS-Wall fixture 5 – 35° D = 28 mm BS-Wall fixture 36 – 70° D = 16 mm BS-Ceiling fixture 5 – 35° C = 30 mm BS-Ceiling fixture 36 – 70° C = 30 mm BS-Eaves fixture 5 – 35° E = 153 mm BS-Eaves fixture 5 – 35° E = 270 mm H = Projection Y = Horizontal cover X = Value from Table 2 K = Headroom = G – X G = Fitting height W° = Pitch angle Table of fitting heights at a pitch angle of 5° to 35° Projection in cm 150 200 250 300 350 400 W = 5° X 26 28 30 32 34 36 Y 148 198 248 298 348 398 W = 10° X 36 43 50 57 74 81 Y 146 196 246 296 346 396 W = 15° X 47 59 70 81 92 103 Y 144 193 242 291 340 389 W = 20° X 58 74 90 106 122 138 Y 141 189 237 285 333 381 W = 25° X 70 89 108 127 146 165 Y 138 184 230 276 316 362 W = 30° X 80 103 126 149 180 205 Y 132 176 220 264 308 352 W = 35° X 89 116 143 170 197 224 Y 126 168 210 252 294 336

7xxxxxx 2 Field Coupled Units with One-piece Cover markilux 6000/5010 Installation Instructions 1 05/01/11 1. Installation example: markilux 6000 Fit the brackets as in the case of single awnings at the points on the wall where the back of the cassette is marked with red dot stickers.  The following steps are not possible for top and eaves fixture of the markilux 6000 and 5010. As the top profile of the cassette cannot be removed when using these fixture types, the coupling of the awning and the fitting of the fabric cannot be carried out with the awning in situ and should be carried out on a suitable working surface. After fitting the fabric the system will have to be installed when completely assembled. 1. Place the master awning (2) in the brackets (1) while it is tilted upwards slightly and allow it to locate in the groove at the rear of the cassette. 2. Connect the drive awning to the mains supply. 3 Tighten the clamp plate bolts (4) to the brackets. Remove the plastic foil (6) around the drive awning. N.B.! Prior to this make sure you read point 4. 4. N.B.! The roller tube is not being held secure at the coupling point. Extend the front profile of the master awning (9) until the folding arms are held by the foil sleeves (8). The fabric strips (27) are then still loose. Secure the front profile during extension by wrapping a belt around cassette and front profile that can be released slowly. 5. Bend the upper lugs of the end cap insert (2) slightly downwards so that it can be pulled off. 6. Unscrew the self-tapping screws (13) in the end cap trim (14) and pull it off. www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk www.samsondoors.co.uk 0800 328 6250 www.samsondoors.co.uk