Novar HPC Manuals

Novar HPC Installation instructions manual (12 pages)

• Identifier: id-2339897
• Brand: Novar
• Device: Controller
• Type: Installation instructions manual, PDF
• Key Aspects: Practical Advice for Users, Regulatory Compliance Information
• UPD Date: 11.06.2026
• Source File: 1947708.pdf
• Pages: 12
• Description: Device technical manual for the Novar HPC. It covers topics such as installation procedures, device reset instructions, product safety, performance optimization.

Key Pages and Contents:

• Turn on the power to the HPC or HPC Plus. Make sure that power to the heat

  pump unit and its control circuitry is on. If the executive module is operating properly, the HPC or HPC Plus begins to control the heat pump in about 3 minutes (after performing a self-diagnostic check

• An auxiliary potentiometer can be connected to the HPC or HPC Plus at the

  terminals labeled “Aux Pot.” Step Procedure 1 Connect the wiper wire to Terminal 1. 2 Connect the clockwise wire to Terminal 2. 3 Connect the counterclockwise wire to Terminal 4 at the “Temp Senso

• Take the following precautions during installation:

  � Observe national and local electrical codes. � Observe voltage and current limits marked on the module. � Do not connect 115 volts to any terminal of the HPC or HPC Plus. They are Class 2 (low voltage) control devices. � Do no

• Setting the Module

  Address Switches Every LOGIC ONE module must have a unique address. The address switch is located in the middle of the terminal strip (Figure 2). Addresses are assigned in the software during system formatting. Use the system printout to find the address of the HPC or HPC Plus bei