Paxar 9662 Manuals

Paxar 9662 Operation & user’s manual (35 pages)

• Identifier: id-1047163
• Brand: Paxar
• Device: Printer
• Type: Operation & user’s manual, PDF
• Key Aspects: Technical Drawings and Schematics, Operational Efficiency Guidelines
• UPD Date: 25.05.2026
• Source File: 1111287.pdf
• Pages: 35
• Description: Setup and usage guide for the Paxar 9662. This guide provides technical guidance on troubleshooting, installation steps, energy usage.

Key Pages and Contents:

• 6. Loosen two screws (4) from bracket (5).

  INSTALLATION FOR CUTTER 1. Turn off the printer 2. Remove the top covers on both left and right sides. 3. Mount the cutter IC to U22 on main board; Take care of the location and direction, the IC hole ix at lower Position. 4. Set bit 3 of DIP

• Outside Media Guide

  13 14

• Calibration for Dispenser Sensor

  If you find the sensor is not so sensitive or mis –detection you can send two commands to calibrate it. Command ASCII Binary Remark33 33 Set sensor without label $R0 1BH 24H 52H 30H Command 0 Se

• Printing Configuration Report

  The rear panel includes Performing the Self Test - An 8-bit DIP switch - A 36-pin parallel port 1. Turn off the printer. Press and hold the FEED button. - A 9-pin RS-232 serial port 2. Turn on the power. - A PS/2 keyboard connector 3. When the message “SELF