Peak Economizer Basic Manuals

PEAK Economizer Basic Model Quick Start Guide Overview To set up your PEAK® Economizer controller, perform the following steps: 1. Install the controller assembly with the included installation instructions. Refer to the PEAK Economizer Basic Model Product Data and Installation Guide (LIT-12013281). 2. Install additional sensors. The factory installs the damper actuator and outdoor air sensor. You must install any other sensors and output connections. 3. Configure the controller using the local display. 4. Run a Self-Test to verify proper operation. Mounting the controller on a DIN rail 1. Horizontally mount a 20 cm (8 in.) section of 35 mm (1.3 in.) DIN rail. 2. On the back of the controller, pull the two bottom mounting clips outward (down). Figure 1: Pull down lower mounting clips 3. Place the controller on the DIN rail. 4. Push the bottom mounting clips inward (up) to secure the controller on the DIN rail. Figure 2: Push up lower mounting clips Wiring 1. Connect the sensors to the inputs on the Economizer controller. 2. Use spade connectors to terminate the inputs and outputs with the Spade termination. Note: Temperature inputs accept a 10k thermistor type 2 sensor. Humidity inputs accept a 0 VDC to 10 VDC sensor. 3. Use the Economizer wiring harness to connect the I/ O with the pin connector termination type. 4. Install the sensors in the appropriate air stream. *241014302090—* 24-10143-02090 Rev — 2019-08-28 (barcode for factory use only) PK-ECO1001-0