Philips DL1 Manuals

INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS-IMPORTANT SAFETY INSTRUCTIONS Lighted lamp is HOT! WARNING- To reduce the risk of FIRE OR INJURY TO PERSONS: Turn off/unplug and allow to cool before replacing lamp. Lamp gets HOT quickly! Contact only switch/plug when turning on. Do not touch hot lens, guard, or enclosure (see diagram/picture). Keep lamp away from materials that may burn. Do not touch the lamp at any time. Use a soft cloth. Oil from skin may damage lamp. Do not operate the luminaire fitting with a missing or damaged shield. SAVE THESE INSTRUCTIONS. Xenon lamps do not require additional shielding. DRL1 DL1 Possible lamps for incandescent fixtures: DL1 - 27W #1156 (included) Single Contact Bayonet Base 20W MR16 Bi-pin (not supplied) STAINLESS CABLE CABLE CRIMP DL1D DRL1 - 35W MR16 Bi-pin (not supplied) - US only DRL1D INSTALLATION 1. Always make sure power is OFF before installing or servicing these fixtures. 2. For incandescent fixtures: Install specified lamp. The screws on the side must be removed to install the lamp. For LED fixtures: The LED modules are factory installed and are not replaceable. Magnetic low voltage transformer is required. 3. Use the cable crimp (included) to hang the fixture. Insert end of stainless cable through one side of crimp, and back through the other side, forming a loop as shown above. Adjust to desired length and crimp tight. Cut off excess stainless cable. 4. Connect to power using the Low Voltage Connector included with the fixture. INCANDESCENT LED DL1DC2/DRL1DC2 - 3.7W Cool White DL1DW2/DRL1DW2 - 3.7W Warm White DL1DC3/DRL1DC3 - 6.4W Cool White DL1DW3/DRL1DW3 - 6.4W Warm White LED Modules (Factory Installed/Not Replaceable) 32000968, revision E 100 Craftway Dr. Littlestown, Pennsylvania 17340-0128 Phone: (717) 359-7131 INSTALLATION INSTRUCTIONS: DL1/DRL1/DL1D/DRL1D page 1 of 2 This fixture is intended for installation in accordance with the National Electrical Code and local code specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage to the ballast and void the warranty. These instructions do not purport to cover all details or variations in equipment, nor to provide for every possible contingency related to installation, operation, maintenance, or mounting situation. Should specific problems occur that are not addressed by these instructions, contact your Sales Representative or distributor for assistance. Retain these instructions for future reference.