SP Controls PLUS U2-1200 Manuals

SP Controls Application Note PLUS U2-1200 Revision B I. Driver Features 1. Command Format This device is controlled through a combination of RS-232 and IR commands; both are necessary for full control of the device. 2. RS-232 Commands IR Commands Power On Power Off Volume Up Volume Down Source: Video Source: S-Video Source: RGB Source: DVI Zoom Up Zoom Down Focus Up Focus Down Menu Adj Up Adj Down Adj Left Adj Right Enter Cancel A/V Mute Freeze Zoom Keystone Up Down Lamp Mode 3. Other Driver Features Default Power Status Feedback: Projector Restart Lockout Timer (Default): None 150 Seconds II. RS-232 Control Wiring For IR wiring, see product manual for the SP Controls device. Wire RS-232 control to a male DB9 as shown. Connect DB9 cable to PLUS serial adapter cable (must be separately ordered from PLUS, part no. TCB-769760000). Connect the PLUS adapter cable to projector small USB port near the audio connector on the back of the projector. See Part IV. below for more information on locating the communication port. Serial Adapters (for NRC only): A & B III. Projector Configuration and Additional Information Warning: The PLUS serial adapter cable (P/N: YCB-C- 769760000) contains active electronics. Ringing it out with a continuity meter may damage the adapter cable. • SPLASH SCREEN DISPLAY OFF: To disable Splash Screen display, navigate through the on-screen menus to Setup, inside the Options menu set the On Screen menu option to OFF. • AUTO SOURCE OFF: To disable Auto Source,navigate through the on-screen menus to Setup and set Auto Source to OFF. © 2004-9 SP Controls Inc. SP Controls reserves the right to modify specifications without notice at any time. GND to 5 RX to 2 TX to 3 SP Controls Device Control Cable (shown from front)