STS 1660 Manuals

Page 1 OPERATOR’S MANUAL MODEL 1660 INTRODUCTION The Series 1660 designates a family of high voltage surge testers that are intended for the testing of coils and windings of all types for defects and weaknesses within the winding. These include such obvious defects as turn-to-turn shorts and layer insulation failures and weaknesses. Specifications Input Requirements 110 Volts +/- 15%, 50/60 Hz, 1.5 /1 A Output Voltage 400 – 5000 Volts Peak Pulse Energy Variable to 0.25 Watt-Seconds Maximum Operating Range Temperature: 0 – 40 deg. C Relative Humidity: 5 – 85 % Non-Condensing Altitude: 0 – 3000 m Vibration: 0 – 2 g Dimensions (WxHxD) 48.26 cm x 13.34 cm x 44.45 cm Weight 20 kg The measurement terminals on the Model 1660 Surge Tester are rated for measurement category I as defined in IEC International Standard EN 61010- 1. Measurement category I is for measurements performed on circuits not directly connected to mains. Do not use this equipment for measurements in measurement categories II, III, or IV. Do not use this equipment for any purpose other than as described in this manual.