System Q PCB820 Manuals

Doc XPCB820 PCB820 Colour NiteDevil Board Camera Instructions E-mail Support: [email protected] Mounting the Camera These board cameras come with four fixing holes at the corners of the board. The camera has two connection leads, one fitted for 12v DC power and video, and a separate cable for menu control. Powering the Camera This board camera requires a 12V DC regulated power supply. The board camera is provided with a 2.1 jack plug connected. The centre pin of the jack plug connects to 12vDC + on the power supply. The black power ground (0v outer connection on jack plug) connects to 12vDC-. It is recommended to use a power supply that is rated higher than the current consumption of the camera e.g. POW150 would be adequate for powering one camera, but when powering more you must look at the bigger power supplies. Using an underrated power supply will cause it to run hot and will greatly reduce its life. If you are using the Easy Connection Kits that comprise of the (CCT801/802/808/809) to power and connect your camera (12V models only) please proceed as per the instructions supplied with The Easy Connection Kit. You will need to cut off the DC Plug ONLY and use the bare wires to connect through a terminal block. The 12V positive is the RED wire, the 0V is the BLACK wire. Always use a 12vDC regulated power supply. This board camera draws 250mA so the power supply must be rated at 300mA minimum to provide sufficient headroom. Video Connection The same fly lead is used for the video connection. The board camera is provided with a BNC connection for video. The inner connection of the BNC is the video connection and the BNC outer is the video ground. Remember that the Video out from the camera is like any other electrical circuit and requires two wires to complete the circuit. When using a coax type cable such as RG59 or similar for video, the outer braid of the coax provides the ground connection and the inner the video connection. Camera Menu This board camera provides additional camera options selected using the OSD menu. To enter the menu, press the centre menu button. The PCB820 520 TVL Hi-Res NiteDevil 3.8mm Board Camera produces excellent quality images. It provides fantastic colour representation and a very clear image. The PCB820 comes with an OSD menu and a small control board. This 12v DC camera offers Digital Noise Reduction, Mirror and Flip functions, Privacy Masking, Day/Night settings plus other functions, and can be used most effectively in covert operations.