Universal Tool UT5765 Manuals

Personal Safety Equipment Use - Safety Glasses Yes Use - Safety Gloves Use - Safety Boots Use - Breathing Masks Yes Use - Ear Protectors Read these instructions carefully before installing, operating, servicing or repairing this tool. Keep these instructions in a safe accessible place. Important Includes - Foreseen Use, Work Stations, Putting Into Service, Operating, Dismantling, Assembly and Safety Rules Operator Instructions Manufacturer/Supplier Product Type RPM Cycles Per Min Model No/Nos Serial No (if any) Product Nett Weight lbs Kg Recommended Use Of Balancer Or Support Recommended Hose Bore Size - Minimum Recommended Max. Hose Length Ins M/M Ft M No Page No 1 20mm Belt Sander UT5765 2.53 1.15 3/8 10 30 10 16,000 Universal Air Tool Company Limited Unit 8 Lane End Industrial Park High Wycombe Bucks HP14 3BY Work Stations The tool should only be used as a hand held hand operated tool. It is always recommended that the tool is used when standing on a solid floor. It can be used in other positions but before any such use the operator must be in a secure position having a firm grip and footing and be aware of the safety rules to be obeyed when using the sander. Foreseen Use of the Tool The tool is designed for the purpose of cleaning or sanding of materials using a continuous abrasive belt. Belts are available in various grades to suit fine finishing or fast material removal. Do not use the tool for any other purpose than that for which it was designed. Do not modify this tool for any other use or for its use as a belt sander without first consulting the manufacturer or the manufacturer’s authorised distributor. Putting Into Service Air Supply Use a clean lubricated air supply that will give a measured air pressure at the tool of 90 p.s.i./6.3 bar when the tool is running with the trigger/lever fully depressed. Use recommended hose size and length. It is recommended that the tool is connected to the air supply as shown in figure 1. Do not connect the tool to the air line Tel No Fax No (01494) 883300 (01494) 883237 system without incorporating an easy to reach and operate air shut off valve. The air supply should be lubricated. It is strongly recommended that an air filter, regulator, lubricator (FRL) is used as shown in Figure 1 as this will supply clean, lubricated air at the correct pressure to the tool. Details of such equipment can be obtained from your supplier. If such equipment is not used then the tool should be lubricated by shutting off the air supply to the tool, depressurising the line by pressing the trigger on the tool. Disconnect the air line and pour into the intake bushing a teaspoonful (5ml) of a suitable pneumatic motor lubricating oil preferably incorporating a rust inhibitor. Reconnect tool to air supply and run tool slowly for a few seconds to allow air to circulate the oil. If tool is used frequently lubricate on daily basis and if tool starts to slow or lose power. It is recommended that the air pressure at the tool whilst the tool is running is 90 p.s.i./6.3 bar. The tool can run at lower and higher pressures with the maximum permitted working air pressure of 100 p.s.i./7 bar. Noise Level Sound Pressure Level 84.7 dB(A) Test Method Tested in accordance with Pneurop test code PN8NTC1 and ISO Standard 3744 Sound Power Level 95.8 dB(A) Vibration Level Test Method Tested in accordance with ISO standard 8662/1 Less than 2.5 Metres / Sec² Air Pressure Recommended Working 6.3 bar 90 PSI Recommended Minimum n/a bar n/a PSI Maximum 7 bar 100 PSI