Vaxcel T0181 Manuals

Headless Screw (D) 150901 Page 1 / 4 ASSEMBLY AND INSTALLATION INSTRUCTIONS T0181 / T0182 / T0183 / T0184 NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Read and save these instructions. BulbType A Max.100W (not included) Take T0181 as an example, T0182,T0183, T0184 follow below installation step. Features 1. Energy saving fixture. 2. Use the dim-to-bright illumination option where you want some minimum illumination through out the night, such as at your front entrance or garage door. Use the dark-to-bright illumination option where you do not need minimum brightness, such as the backyard or back porch. 3. When in manual override mode, use wall switch to keep the light ON till dawn. Important to Know 1. Read all instructions carefully before installation and operation. 2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified electrician. 3. Before installation, shut off power at the main fuse or circuit breaker box. Be aware that simply turning off the wall switch is not sufficient to prevent an electrical shock. 4. This fixture requires a 120V AC, 60 Hz power source. 5. Do not attempt to take the lantern apart; there are no serviceable parts inside. 6. To avoid sensor damage by lightning or electrical surge, make sure the grounding wire is securely connected. 7. For general safety and to avoid any possible damage to the sensor, be sure the power is switched "off" before replacing the bulb. Maximum Wattage: 100W Incandescent bulb Work Temperature: -4ºF ~ 104ºF House Grounding Wire Green Grounding Screw (C) Wire Nut (E) Mounting Screw (B) Headless Screw (D) Outlet Box Fixture Wire Lock Nut (F) Back Plate Rubber pad(G) Fixture Ball Nut(H) Mounting Plate (A) Fixture Grounding Wire Hardware Package (included)： Mounting Screw (B) Green Grounding Screw (C) Lock Nut (F) Wire Nut (E) Rubber Pad (G) Mounting Plate (A) Ball Nut (H) WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. 1. Thread two headless screws through the mounting plate, and then secure them with four lock nuts (two on each side of the mounting plate). Adjust the length of the headless screws if necessary. Note: Make sure that the headless screws are lined up horizontally in order to make the fixture level. Installation Steps Turn off the power at fuse or circuit box.