Vertiv Liebert EXS Manuals

Liebert® EXS™ Installer/User Guide 10-kVA, 60-Hz, 208/220-V, Three-phase UPS

LIEBERT® EXS™ UPS 208/220 ‑V 15 – 20 KVA Quick Installation Guide 590-1912-501B/SL-26156_REV1 1 IMPORTANT: Before installing, connecting to supply or operating your Liebert EXS UPS, please review the Safety and Regulatory Statements sheet. For detailed installation, operating, maintenance and troubleshooting information visit the EXS product page for the EXS User Guide available at www.VertivCo.com. INSTALLATION Inspecting the UPS Inspect the UPS for any signs of obvious damage. If damage is visible, do not proceed. File a damage claim with the carrier immediately and send a copy to: Vertiv Corporation 1050 Dearborn Drive P.O. Box 29186 Columbus OH 43085 Attn. Traffic Department Choosing a location Install the UPS in a clean, well- ventilated environment with the ambient temperature range of 32°F to 104°F (0°C to 40°C). For installation and maintenance, 3 ft (914 mm) clearance is required in the front and rear of the unit. For proper ventilation during normal operation, leave 8 in. (203 mm) clearance on the rear. No side clearance is required for installation or operation of the UPS. Handling and unpacking the unit The UPS ships on a pallet and is equipped with casters that permit two or more people to roll it off the pallet for installation. Use a forklift or pallet jack to move the palleted UPS as close as possible to the installation location before removing packing material or loosening shipping brackets. 1. Remove the protective packaging, shown in the illustration at the top-right. 2. Locate the accessories package on top of the UPS and set aside. 3. Use a 16-mm (5/8 -in.) wrench or socket to un-bolt the shipping brackets from the pallet. 4. Un-bolt the shipping brackets from the front and rear of the UPS. Remove the front lower panel from the UPS to remove the front bracket. 5. Make sure the leveling feet are raised so they do not interfere when rolling the unit on the casters. 6. Roll the unit down the ramp to the installation location, see the illustration above, and lower the leveling feet to fix the UPS in the install location. Repositioned ramp placed for unit transfer to installation location Removing Packaging and Moving the UPS Ramp in shipping position Packaging

Liebert® EXS™ Quick Start Guide 10-kVA, 60-Hz, 208/220-V, Three-phase UPS

Liebert® EXSTM 60kVA UPS User Manual