Maxitrol MP2+ Installation Manual

Level 0 Level 1 Level 2 Level 3 Level SW1 Dipswitch position Accessible Menus 0 1-closed, 2-closed None 1 1-open, 2-closed Process 2 1-closed, 2-open Process and Operation 3 1-open, 2-open Process, Operation and Diagnostic 7 © 2006 Maxitrol Company, All Rights Reserved ...

Maxitrol MP2+ Dimensions, page 5. Wire the MP2+ System and TM02 together as shown in fig. A, page 6. Apply 24 VAC power to AM02+ and TM02. MP2+ System will default to the “READY” program start position of Program #1. NOTE: Any future power interruption to the AM02+, will cause the MP2+ System t ...

stall, operate, and/or maintain the MP2+ system. Failure to do so may result in improper operation and/or component dam- age. Installation shall conform with local codes, or in the absence of local codes, in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA54 or CSA B149.1 as is applic ...

Maxitrol MP2+ Dimensions, page 5. Wire the MP2+ System as shown in figure A, page 6. Apply 24 VAC power to AM02+. MP2+ System will default to Process 1 of Program #1. NOTE: Any power interruption to the AM02+, will cause the MP2+ System to default to the Process 1 position of the program in use reg ...

Maxitrol MP2+ Installation Guide www.maxitrol.com © 2006 Maxitrol Company, All Rights Reserved I~L + ...