Citadel TouchStar TS3000 Operation & User’s Manual

Citadel TouchStar TS3000 5.Place the bootable floppy in the drive and reboot the system. This time, the TFFS drivers will be loaded from the boot image in the Flash Array. 6.From the A:\ prompt, run the standard DOS format Format C:/S/U Once the format is completed, remove the floppy and reboot the system. Real-Time Clock The CMOS real ...

Citadel TouchStar TS3000 PCMCIA cards are inserted into Slot 0 (lower) or Slot 1 (upper) on the rear panel by holding the card with the connector facing toward the slot and sliding the card into the slot until firmly seated. System access of the card can be verified under the operating system software. Antenna Connection TouchStar syste ...

Citadel TouchStar TS3000 INSTALLATION & MAINTENANCE _____________ 2 PHYSICAL INSTALLATION TS3000 – Fixed Installation The TS3000 TouchStar can be mounted almost anywhere that is convenient to the operator. The mounting location must be near a standard 110VAC electrical outlet, and there must be sufficient space below the unit for cabl ...

APPENDIX___________________________________A TROUBLESHOOTING, TECHNICAL SUPPORT & EQUIPMENT RETURNS This chapter provides a checklist of common problems and their potential solutions. Initial Checklist Perform an initial check of the TouchStar unit as follows: 1.Check the unit for any signs of exterior damage. ...

Citadel TouchStar TS3000 Serial Communication Ports The TouchStar provides two serial ports, labeled COM1 and COM2. These ports are used to connect devices such as serial printers, a mouse, an external modem, or to make a serial network connection. If factory configured to do so, either serial communication port can also support a seria ...

Citadel TouchStar TS3000 APPENDIX___________________________________C SPECIFICATIONS CPU 486SLC2-25/50 (50MHz) Operating System Compatibility Fully PC-compatible, industry-standard software environment MS-DOS, Version 3.3 through 6.22 Windows, Version 3.1 Windows for Workgroups 3.11 VRTX Real-Time System, etc. System Memory 4, 8, 12, an ...

Citadel TouchStar TS3000 supplied as 4MB, 8MB, 12MB or 16MB of dynamic RAM (DRAM). The specific memory configuration is determined at the time the system is ordered. • System Software A 256Kx8 flash device contains the System BIOS, the Video BIOS, and a Setup Utility. • Network Interface Card and Software The TouchStar is factory-con ...

Citadel TouchStar TS3000 completed. Alternatively, the port sequence can occur during an interrupt service routine before re-enabling interrupts. If these precautions are not observed, an interrupt service routine could potentially intervene between the output to port 70H and the subsequent I/O to port 71H, overwriting the port 70H valu ...

Citadel TouchStar TS3000 Touchscreen Does Not Respond The video display appears to be working properly, how- ever, touching the screen does not cause anything to happen. Possible Causes and Solutions The touchscreen drivers did not load, the touchscreen may be disconnected or defective. Reboot the TouchStar. If this does not solve the p ...

PCMCIA Slots Slot A Type PCMCIA V2 Compatibility Type II; Slot A can be used alone or with Slot B while using Type II devices. Type III; Slot A must be used alone while using Type III devices; do not use Slot B Slot B Type PCMCIA V2 Compatibility Type II; Slot B can be used alone or with Slot A while using Type ...

Citadel TouchStar TS3000 Audible Indicator The TouchStar is equipped with an audio beeper capable of producing tones at output levels of 95dBA at one foot. This can be used to alert the system operator to error conditions, ac- knowledge data entry or to provide other (audible) feedback. B - SYSTEM REFERENCE ...