DeWalt DW505 Instruction Manual

ALWAYS ensure workpiece is anchored or clamped firmly. If drilling thin material, use a wood “back-up” block to prevent damage to the material. 1. Use sharp drill bits only. For WOOD, use twist drill bits, spade bits, power auger bits, or hole saws. For METAL, use steel twist drill b ...

DeWalt DW505 Instruction Manual DW505 1/2" (13 mm) Dual Speed Range Hammerdrill final page size: 8.5 x 5.5 in ...

DeWalt DW505 hammerdrill for backing out screws or jammed bits. It is located above the trigger, shown in Figure B. To reverse the hammerdrill, turn it off and push the reversing lever to the left (when viewed from the chuck end). To position the lever for forward operation, turn th ...

DeWalt DW505 (Mar17) Part No. N482746 DW505 Copyright © 2003, 2006, 2011, 2017 DeWALT The following are trademarks for one or more DeWALT power tools: the yellow and black color scheme, the “D” shaped air intake grill, the array of pyramids on the handgrip, the kit box configuration, ...

DeWalt DW505 DW505 Chuck capacity 1/2" (13 mm) R.P.M 0–1270 – 0–3000 Bits, metal drilling 1/2" (13 mm) low speed Wood, flat boring 1–1/2" (38 mm) low speed Bits, masonry drilling 3/4" (19 mm) soft materials Hole saws 2–1/8" (53.9 mm) – Low speed Repairs � WARNING: To assure product SAFETY and RELIABILITY, repairs, ma ...

DeWalt DW505 This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage. � DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. � WARNING: Indicat ...

DeWalt DW505 � WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE The term “power tool” in the warnings refers to your mains- operated (corded) power too ...

DeWalt DW505 symbols and their definitions are as follows: V ......................... volts Hz .......................hertz min .....................minutes or DC ......direct current ...................... Class I Construction (grounded) …/min ..............per minute BPM ....................b ...

work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a ) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintain ...