Jet XACTA Saw Deluxe Operating Instructions And Parts Manual

cover door, loosen lock nut (A, Fig. 19) and turn adjusting stop screw (B, Fig. 19) on the front trunnion in, or out. The adjusting stop screw should stop against the front trunnion bracket when the blade is 90° to the table. 6. Tighten the lock nut (A, Fig. 19). 7. Set the blade at 45 degrees to the tabl ...

Jet XACTA Saw Deluxe Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Service Centers located throughout the United States can give you quick service. In most cases, any of these Walter Meier Authorized Service Centers can authorize warranty repair, assist you in obtainin ...

not start Overload tripped Saw unplugged from wall or motor Fuse blown or circuit breaker tripped Cord damaged Allow motor to cool and reset by pushing off switch Check all plug connections Replace fuse or reset circuit breaker Replace cord Does not make accurate 45° or 90° cuts Stops not ...

Jet XACTA Saw Deluxe Main Saw Container 1 Table Saw (A) 1 Switch (B) 1 Table Insert (C) 1 Owner's Manual (D) 1 Warranty Card (not shown) Main Saw Container Extension Tables Two extension tables are packaged in individual boxes. Extension Tables Side Cover Box 1 Side Cover Contents of Side Cover Box Small Box The small box consists of the foll ...

Jet XACTA Saw Deluxe 2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with all of these warnings may cause serious injury. 3. Replace the warning labels if they become obscured or removed. 4. This table saw is designed and intended f ...

708097 Dado Insert 708118 Universal Mobile Base Parts Ordering Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848, Monday through Friday (see our website for business hours, www.walterme ...

Jet XACTA Saw Deluxe to do this may result in serious personal injury. Cleaning Note: The following maintenance schedule assumes the saw is being used every day. Daily: ˆ Wipe down the table surface and grooves with a rust preventive. ˆ Clean pitch and resin from the saw blade. Weekly ...

Jet XACTA Saw Deluxe marker Blade alignment with the table is adjusted at the factory. After a period of use, or, after moving the saw to another location, the blade may no longer be aligned with the table. To check and align the blade (refer to Figure 16): 1. Disconnect the saw from the power source. 2. Raise th ...

Jet XACTA Saw Deluxe Lateral alignment The saw blade and riving knife must be in line as close as possible with each other (lateral alignment) for the prevention of kickback. Upon initial blade guard and riving knife installation no further adjustment should be necessary. Alignment should be checked and adjusted, if required, after each blade change. C ...

Jet XACTA Saw Deluxe assembly or operation! Failure to comply may cause serious injury. Shipping Contents Unpacking Remove box and wood crating completely from around saw. Check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping materia ...