Jet JTS-315LA Operating Instructions Manual

Product / Produkt / Produit: Table saw / Tischkreissäge / la scie circulaire JTS-315LA 10001910AM Brand / Marke / Marque: JET Manufacturer / Hersteller / Fabricant: TOOL FRANCE SARL 9 Rue des Pyrénées，91090 LISSES, France We hereby declare that this product complies with ...

Jet JTS-315LA blade, always disconnect saw from power source, unplug! Remove the saw guard (A, Fig 1) and table insert (B). Raise sawblade fully. Place the counter holder (a) on the saw blade flange Fig.13 Using the wrench (c), turn out the screw (b) in the running direction of the saw blade. Fig.13 Fig.13 Remov ...

Jet JTS-315LA operating a table saw. - safety goggles - ear protection - dust protection Do not wear gloves while operating this machine. For the safe handling of sawblades wear work gloves. Observe the chapter “save operation” in this manual. Check the correct rotation of the sawblade before operating the machine. Do not start cutti ...

Jet JTS-315LA rear table extension (X, Fig 10). Fig 10 Attach two support arms (Y, Fig 11). Adjust the table to be level and tighten the nuts. Fig 11 5.3 Dust connection Before initial operation, the machine must be connected to a dust extractor. The suction should switch on automatically when the saw is switched on. Attach the connec ...

Operating Instructions Dear Customer, Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared for the owner and operators of a JET JTS-315LA table saw to promote safety during installation, operation and maintenance procedures. Please read and understand the information contain ...

Jet JTS-315LA missing, do not attempt to assemble the machine, do not plug in the power cord, do not turn the switch on until the missing parts are obtained and installed correctly. 5.2 Assembly Assemble tool in strict accordance with these instructions. Only if you follow the instructions exactly does the machine conform to the ...

Jet JTS-315LA General notes: Maintenance, cleaning and repair work may only be carried out after the machine is protected against accidental starting by pulling the mains plug. Repair and maintenance work on the electrical system may only be carried out by a qualified electrician. Consult a qualified repair shop if a malfunction or dam ...

Jet JTS-315LA place – serious risk of injury! Do not stand on the machine. Connection and repair work on the electrical installation may be carried out by a qualified electrician only. Always unwind any extension cords fully. Have a damaged or worn cord replaced immediately. Do not use the machine when the ON- OFF switch does not ope ...

Jet JTS-315LA 9 Rue des Pyrénées, 91090 LISSES, France www.jettools.com M-10001910AM 2019-03 ...