Flomec OM025 Instruction Manual

deterioration. Remove, inspect and clean the rotors, also check that the magnets have not been chemically attacked. Check the measuring chamber for damage or scoring & redress if necessary, the rotor shafts should NOT be loose o ...

totaliser, rate totaliser or batch controller then the pulse output from the meter has been factory wired to the flow input of the readout instrument. As a default the reed output is pre-wired and DIP switches set for a integral ...

Flomec OM025 Notes 5.1 TROUBLE SHOOTING Symptom Solution 1. 1. Ground shield of signal cable 2. Re-route cable from high electrical energy sources 2. 1. Remove source of air or gas entrapment 2. Install an upstream air eliminator 3. 1. Increase back pressure on pump 2. Install a fast response one way check valve 3. Install a surge ar ...

Flomec OM025 1.0 General Page 1.1 Overview 2 1.2 Operating principal 2 1.3 Model number information 3 1.4 Specifications 4 2.0 Installation 2.1 Mechanical installation 5 2.1.1 Orientation 5 2.1.2 Flow conditioning & locations 6 2.2 Electrical installation 6 2.2.1 Instrument cable 6 2.2.2 Hazardous area wiring 7 2.3 Pul ...

Flomec OM025 Specifications 4 Model coding 15mm ( 1/2" ) 25mm ( 1" ) 40mm ( 11/2" ) 50mm ( 2" ) Body material A Aluminum S 316 Stainless Steel H High pressure stainless Rotor material Aluminum Stainless steel 9 Application specific Bearing type 1 Ceramic ( SS rotors ) 4 Hardened steel roller bearings ( Alum. rotors ) O-ring material ...

Flomec OM025 Models : OM025, OM040 & OM050 Flomec Factory 1 / 19 Northumberland Road, Caringbah NSW 2229, Sydney AUSTRALIA tel : +61 2 9540 4433 fax : +61 2 9525 9411 email : [email protected] website : www.flomec.com.au USA 916 Belcher Drive Pelham, AL 35124 USA Tel : +1 205 378 1050 Fax : +1 205 685 30 ...

Flomec OM025 pulse output board, undo the 4 cap screws (10), remove the terminal cover (9) carefully to avoid putting strain on the terminal connections. The pulse output board (6) can now be accessed and removed if necessary (screws 7). If ...

# The fluid is compatible with the meter materials of construction using appropriate information such as fluid compatibility charts and site experience. # Application and process conditions are compatible with the meter specifications. Minimum and max ...

Flomec OM025 apparatus, wiring to an Intrinsically Safe Instrument or wiring to the Exd explosionproof option( Exd IIB T4/T6 ) wiring techniques must be undertaken in accordance with the rules, regulations and requirements applying to the te ...