Lytx DC3P Installation Manual

27 What are the OPERATING SPECIFICATIONS of the event recorder? The input voltage is 12V to 24V DC (9V min. to 30V max.). The operating temperature is -40 to 185 °F (-40 to 85 °C). APPENDIX A. UNDERSTANDING THE LED STATUS BEHAVIORS There are two LED status lights on the DC3P event recorder, one on either s ...

Lytx DC3P 20 one-time use and may need to be replaced after removal. Please refer to the vehicle service manual for information. Step 1: Starting from below the dash near the kick panel, route the RJ45 end of the cable up the door pillar underneath the vertical door/window trim to the top of the door pillar. Step 2: Ro ...

Lytx DC3P 18 source. The brown wire is an ignition-sense, used by the event recorder to perform functions such as activating the IR Illuminator when the vehicle ignition is switched on. The black wire is ground. Wiring Suggestions WARNING – You must always disconnect the battery ground cable before you work on an ele ...

Lytx DC3P 6 Par la présente, Lytx, Inc. déclare que ce DC3P est conforme aux exigences essentielles et aux autres dispositions de la directive 1999/5/CE qui lui sont applicables. Swedish Härmed intygar Lytx, Inc. att denna DC3P står I överensstämmelse med de väsentliga egenskapskrav och övriga relevanta bestäm ...

Lytx DC3P 22 Note: Hibernation mode is an optional mode that can be configured to use with the event recorder. Hibernation mode may not be configured in all models. For event recorders that have been configured with hibernation mode, the right status light should go out within a few seconds after switching the vehicle ...

Lytx DC3P 21 TESTING THE CONNECTIONS Red Wire Connection (Continuous Power) Reconnect the vehicle battery. Once the power and ground connections are made to the vehicle, the following items should appear: LED status light to the LEFT of the interior-facing lens turns green for approximately 30-35 seconds LEFT status l ...

Lytx DC3P 11 INSTALLATION PROCEDURE Thoroughly Clean and Dry the Glass The following steps describe installation using the windshield-mounting bracket. This is the most common installation method and applies to most sedans and light vehicles with sloped windshields and standard rear view mirrors. Unless the vehicle man ...

Lytx DC3P 24 DC3P Event Recorder Installation Complete The DC3P event recorder is installed and ready to use.  Finalize all electrical connections. Use cable-ties to bundle and secure all wires so they don’t come loose.  Replace any trim pieces on the door pillar and dash that were removed.  Make sure the c ...

3 SAFETY INSTRUCTIONS Read and follow the instructions and precautions in this guide and all documents referenced in this guide when installing the DC3P event recorder (ER). Always refer to the vehicle manufacturer’s service manual for proper installation and wiring of any aftermarket devices, including the ...

Lytx DC3P 25 FREQUENTLY ASKED QUESTIONS GENERAL INFORMATION The DC3P event recorder communicates via cellular, much like a cell phone. Once powered, it will begin to search for a cellular signal and may begin to send or receive information. The status lights will indicate what is happening. See Appendix A for a comple ...

Lytx DC3P 17 COMMON MISTAKE: Large commercial vehicles often have many objects near the top of the windshield (e.g. large sun visors, window tint, circulation fans, etc.) that can block both the interior and exterior-facing lens. To avoid this, you must carefully consider the mounting location. Hold the VER in a potent ...