Sutter Lambda DG-4PLUS Operation Manual

24 Figure 3-4. Optical pathway based on filter position. The position of the Output Galvanometer must be coordinated with that of the Input Galvanometer to complete the optical pathway to the Light Guide Port (shown above). The Output Galvanometer angle is also expressed in an arbitrary ...

Sutter Lambda DG-4PLUS 35 4. EXTERNAL CONTROL OPERATIONS The Lambda DG-4 has both serial and parallel interfaces but these two interfaces should not be connected simultaneously. The parallel port provides you with the fastest remote interface possible. The serial port connection provides you with a similar ran ...

Sutter Lambda DG-4PLUS 37 Table 4-3. DG-4-Only filter position movement commands. Move to Nominal Filter Position Value (Decimal; hexadecimal; binary) Move on … Atte- nuation Physical Filter Position Notes 0 0, 00, 00000000 Command 0% 0 Light is blocked (“Shutter Closed”) 1 1; 01; 00000001 Command 100% 1 ...

55 APPENDIX A. LIMITED WARRANTY � Sutter Instrument Company, a division of Sutter Instrument Corporation, limits the warranty on this instrument to repair and replacement of defective components for two years from date of shipment, provided the instrument has been operated in accordanc ...

Sutter Lambda DG-4PLUS 3 � Increased filter switching speed: The “PLUS” version is able to switch between adjacent filter positions in 0.5 milliseconds. A switching time of 1 millisecond applies only when switching between the most spread-apart filters. � Light output is increased by 30% in the “PLUS ...