Sunstream Evolve 30 Assembly Manual

Install the Sauna Roof Lift the roof up and over top of the sauna walls. If you are installing the sauna in a restrictive space and are unable to walk down the sides of the saunas, it may be necessary for one person to go inside the sauna. Hook the right side corners of the roof over the ...

Sunstream Evolve 30 Interior Control Panel Temperature Sensor FRAGILE DO NOT TOUCH ...

Sunstream Evolve 30 Chromatherapy Lighting The color LED light panel is controlled by the remote control and is NOT connected to the sauna wall controller. ...

Sunstream Evolve 30 IMPORTANT For temporary purposes, insert a foot or two of the flexible plastic strip on the inside of the side wall glass panel. This will hold the glass panel in place and assist in following assembly steps. ...

Sunstream Evolve 30 Connect the circular connector to power supply box. Align the groove in connector to properly insert. Thread the cuff of connector on fully Attach the 'D-Sub' computer style connector as shown Plug in all heater leads to receptacles in the power supply box. Electrical Connections Inside ...

Remove Side Wall Heater Guards The wooden lattice work in front of the heaters is referred to as the heater guard. These are held on with strong magnets. It is necessary to remove the heater guards from the two side walls in order to install the leg heater and the sauna bench. Leg Heate ...

Sunstream Evolve 30 Reinstall the roof panels and feed your audio cord through the hole in roof. ...

Sunstream Evolve 30 Care and Maintenance It is advisable that you always sit on towels when using your sauna to minimize any sweat stains on the wood surfaces. Following use, wipe wood with damp cloth of any sweat that soaks through your towels etc. to minimize staining of the wood. The carbon panel heater ...

Firmly press flexible glazing strip into wood channels along the outside of the glass panels. It may not be necessary to use the flexible glazing for the full length of sides, tops and bottoms of the two glass panels. Use the glazing strip where it fits into the channel along side glass ...

Sunstream Evolve 30 Intall Corner Seal Firmly press the corner seal on to the edge of the front glass panel Remove temporary plastic glazing strip from the inside of side glass panel ...

Sunstream Evolve 30 Carefully lift the roof upward, about 1/2", enough to tilt the front glass into position Lower the roof so that the front glass panel fits into the slot. ...

Sunstream Evolve 30 Lift the front wall into position carefully lowering the bottom of the wall into the channel on the floor base. Prop up one end of the front wall to enable connection of the door heater electrical lead. Ensure that the door heater electrical is protruding from bottom of front wall frame A bit of plastic wrap can serve to hold the conn ...