CPC MultiFlex PAK Operation & User’s Manual

MultiFlex PAK Hand-Held Terminal Interface • 37 8.4.1. The PAK Configuration Menu Press F1 at any time to access the PAK Con- figuration Menu. To select one of the six sub- menus, press the RIGHT ARROW key, enter the number of the sub-menu you wish to access, then press DOWN ARROW key twice to access the sub-menu’s first screen. ...

CPC MultiFlex PAK 026-1712 Rev 3 03-JAN-2008 4.2. The Relay Outputs 4.2.1. Output Types Supported by the MultiFlex PAK 4.2.2. The PAK Default Output Assignments 4.2.3. Wiring The MultiFlex PAK boards have Form C relay contacts. Figure 4-3 shows how to wire the three-terminal Form C contact. One wire of the two-wire connection shou ...

5 Board Status LEDs When a MultiFlex board is powered up, you will be able to determine the operating status of the board by observing its status LEDs. Figure 5-1 shows the location of the MultiFlex’s status LEDs. 5.1. Status LED The Status LED simply blinks GREEN once per second to show that the board is powered and ope ...

CPC MultiFlex PAK Mounting and Powering • 5 A center-tapped transformer may power both center-tapped and non-center-tapped boards at the same time, as long as none of the non- center-tapped MultiFlex boards are old-style MultiFlex boards. If an old-style MultiFlex shares the same center-tapped transformer as a device that uses the center tap, boards ...

CPC MultiFlex PAK MultiFlex PAK E2 Interface • 25 7.1.2. Deleting a PAK To remove a PAK from the E2: When PAKs are deleted in this way, E2 will always delete the highest numbered PAKs first. Therefore, if you have seven PAKs (numbered 1- 7) and you change the number of PAKs to five, the E2 will delete board #6 and #7, ...