Tinycontrol 5G10A v2 Manual 

www.tinycontrol.eu Change outputs state display Management by WWW. 1. Control Panel Any text description, max 8 chars Reset time – for 0 normal outputs work (ON/OFF) , for time > 0 output after push button change state and return to state before after the specified time in seconds (max 65534). click cause change relay state on opposite (OUT0 relay on board) automatic socket arming at fixed time (two panes: one - time arming, second - break time) Set State All output simultaneously according to combo box ...

www.tinycontrol.eu Reading XML data Enter the IP address and the page name eg 192.168.1.100/st0.xml The values ​of the sensors should be divided by 10 Control Panel: - Dynamic data - st0.xml - Static data - st2.xml Events Config: s.xml Watchdog: w.xml Scheduler: sch.xml Network Config: board.xml Working time: s_time.xml using the Timezone Switching sockets http request You can arm / switch set out without clicking on the buttons in the control panel, making use of the following commands: IP / outs.cgi ? out = xxxxx - switches set the output to the o ...

11 www.tinycontrol.eu Firmware Upgrade In the event that there is a new version of the software or special version for application, it is possible to load such software to the device. This can be done remotely over the ne- twork using TFTP. You my upgrade firmware on two way: 1. By dedicate software „LAN Controler Tools” (find controler or put IP and click „Upgrade Firmware”). 2. By any TFTP client, description below. Send firmware file by TFTP, you have 5 second (Green LED on RJ45 socket blink) to start send firmware when modul run after reset ( ...

www.tinycontrol.eu Reading XML data Enter the IP address and the page name eg 192.168.1.100/st0.xml The values ​of the sensors should be divided by 10 Control Panel: - Dynamic data - st0.xml - Static data - st2.xml Events Config: s.xml Watchdog: w.xml Scheduler: sch.xml Network Config: board.xml Working time: s_time.xml using the Timezone Switching sockets http request You can arm / switch set out without clicking on the buttons in the control panel, making use of the following commands: IP / outs.cgi ? out = xxxxx - switches set the output to the o ...

www.tinycontrol.eu 5. Network Configuration e-mail client set- tings parameter. After changing the settings in order to test the customer - should be save your settings - the „Save Config” button. Remote Control - working as a server (receiving packets and enable / disable the cor- responding socket). Terminal working as a server can be triggered from any number of clients (Lan Controllers), the condition is set to the same password. ...

www.tinycontrol.eu 5. Network Configuration e-mail client set- tings parameter. After changing the settings in order to test the customer - should be save your settings - the „Save Config” button. Remote Control - working as a server (receiving packets and enable / disable the cor- responding socket). Terminal working as a server can be triggered from any number of clients (Lan Controllers), the condition is set to the same password. ...

www.tinycontrol.eu Functional Description Event Table With this change, you can flexibly define thresholds and intervals in which such slot is to be enabled / disabled. If you have the proper checks the condition of a number of sensors is to force the state to be the sockets that was last registered event. 3. Watchdog Time to respond is 4 second, after this time one PING failures is counting. In time wa- iting to respond, another IPX aren’t send ping, this may causa stretch time statment that another IPX adress is inaccessible. Amount PING failures, ...