Datalogic Controller SC6000 Installation Manual

2.7.1 Master Working Controller REDS configuration After the Net and Scanner setting, complete the Working configuration as follow: 1. Redundancy Parameters � Reds Functionality = checked. 2. Redundancy Parameters � Topology Redundancy = Master Working. 3. Data Communication settings � Built-in Ethernet � Line Parame ...

Datalogic Controller SC6000 Input 1 = PS – No presence sensor signal for an interval that is too long Input 2 = ENC – No encoder signal for an interval that is too long Redundancy: diagnostic digital input information about the Standby system is reported. The digital input diagnostic information ...

Datalogic Controller SC6000 3.9.1 SC6000 error message syntax: � WS#xxx where WS means Working Standby and xxx is the error number as listed in the table: � WA#xxx where WA means Working Active and xxx is the error number as listed in the table: � PS#xxx where PS means Protecting Standby and xxx is the error number as listed in the table: � PA#xxx ...

The switch over is the situation that leads to a swapping of the role that the controllers play in the redundant system. The Standby controller is responsible for the decision to switch over as a final result of the evaluation of the local and remote diagnostics or of parcel error count conditions. This is how the switch over t ...