CHIEF Vulcan ADU CHH5404 Original Instruction Manual

harmful if swallowed and can cause redness and irritation if it comes into contact with your eyes. Be careful when replacing arms and electrodes. If this machine comes into contact with water that penetrates into its inner parts, power off the machine immediately and unplug the power plug. Foll ...

CHIEF Vulcan ADU CHH5404 solely by trained personnel, able to perform the specified operations safely. When possible, the machine should be powered off, the power cord unplugged and the compressed air supply disconnected. Warning! After powering off the machine, some of its inner parts remain live for several min ...

CHIEF Vulcan ADU CHH5404 1. Refer to the assembly figure on page 17. 2. Power off the machine and electrically disconnect it from the mains as a precaution. 3. Wait until the lamp is cold before continuing. 4. Disconnect the lamp from the generator by disconnecting the ilme supply connector and the CAN communication cable. 5. Remove the two no. 5 A ...

CHIEF Vulcan ADU CHH5404 INTRODUCTION ................................................................................................................................ 3 SYMBOLS USED ................................................................................................................................ 3 IDENTIFICATION OF THE MAIN PARTS OF THIS MACHINE ..... ...

CHIEF Vulcan ADU CHH5404 Refer to the control unit manual for the operating information. If necessary, calibrate the lamp's temperature sensor by placing the calibrator on the surface to be processed, press the calibration start key (22) and wait until the screen displays that control unit calibration is finished. Refe ...

CHIEF Vulcan ADU CHH5404 CAREFULLY BEFORE INSTALLING AND USING YOUR MACHINE The purpose of this manual, and enclosed documents, is to transmit information necessary for the user to use this product skillfully and safely. This manual provides information on safety, installation, use, maintenance and disposal of this product. This man ...

moving this machine, any obstacles on the floor could cause the wheels to lock and overturn the machine. Check that the machine is not exposed to water splashes or penetration of liquids, dirt, metal filings, etc. Check that the cables do not get in people's way and do no ...

1 – Compressed air inlet line 2 – Chiller power cord connection 3 – CAN cable to connect calibrator and lamp controls 4 – Pressure gauge (to be set to 1 bar) 5 – Air outlet for lamp cooling 6 – Lamp power cord connection 7 – Generator power cord 8 – Generator 9 – IR-Lamp 10 –Trolley 11 � ...

FOR CAR BODY SHOP ORIGINAL INSTRUCTION MANUAL TROLLEY ITEM CHH5404 GENERATOR ITEM CHH5402 CHILLER ITEM CHH5403 ITEM CHH5408 ITEM CHH5409 CHIEF Automotive Technologies 996 Industrial Drive . Madison, IN 47250 Phone: 800-445-9262 Fax 866-275-0173 EMAIL [email protected] DOCUMENT NUMBER: IN20784 EDITION: ...

system, suitable for bodywork applications. New Vulcan ADU control touch screen with user-friendly graphics, to aid the operator in using this machine. Choose between automatic and manual mode or according to temperature profiles. USB interface to export data relating to perfo ...

Phone: 800-445-9262 Fax: 866-275-0173 EMAIL: [email protected] ...