rangeiot RZ-A Installation & Programming Manual

A IMPORTANT: Before installation, make sure the latch is fully retracted (in the unlocked position) . B Route the cable below the latch and insert the cylinder tailpiece horizontally through the slot in the latch. 2 / 6 4 Install interior assembly Connect the cable and ensure tight cable connection. B Rotate the turnpiece in vert ...

rangeiot RZ-A Quick Set Up IMPORTANT: The default Master Code is 12345678. It is recommended that you change it to a code of your own Notes: · Each step of a function programming sequence needs to be completed within 5 seconds. · When setting is unsuccessful, the indicator light will flash 5 red lights and exit programming mode. Change Master Code Wait for Green L ...

rangeiot RZ-A Item Specifications Remarks AA alkaline battery x4 (Operation voltage: 4.6~6.0V) Last up to one year (10 times open/close per day) Battery (Use new, non-rechargeable Alkaline batteries only.) Parts Illustrations The default Master Code is 12345678. It is required that you change it to a code of your own before programming. Keypad Cylinder Multi-Functi ...

rangeiot RZ-A Factory Default Settings The turnpiece cannot rotate or operate the lock. Remove and re-install the lock, making sure that the turnpiece is in vertical position. The lock cannot be locked or unlocked by the keypad. Make sure that the codes are not disabled. If needed, restore the lock’s default settings. The keypad doesn’t respond when touched ( no ...

rangeiot RZ-A Information & Safety Warnings Protect your User Codes and Master Code. Restrict access to your lock’s interior assembly and routinely check your settings to ensure they have not been altered without your knowledge. IMPORTANT: The default master code is 12345678. Your must change this code to a code of your own before the electronic features of this p ...

rangeiot RZ-A This guide contains important information about your lock. PLEASE KEEP THIS GUIDE This guide contains important information about your lock. Installation & Programming Guide RZ-A ...

35 mm to 50 mm A A B C D B C D 1" 25 mm 1 Prepare the door and check dimensions Measure to confirm that the hole in the door is 2-1/8" (54 mm) Measure to confirm that the backset is either 2-3/8" or 2-3/4" (60 or 70 mm) Measure to confirm that the the hole in the door edge is 1" (25 mm) Measure to confirm that the door is 1-3/8" to 2" (35 ...